the radio off, and then on
again.
Good luck. I hope it works for you.
Dave Hachadorian, K6LL
Yuma, AZ
-Original Message-
From: Jeff Schmidt
Sent: Friday, February 26, 2016 9:34 PM
To: elecraft@mailman.qth.net
Subject: Re: [Elecraft] K3 unable to change passband control
shift amount
Hi, Don,
After talking with Howard at Elecraft Wed AM, I did exactly what you
recommend below.
I did the EEINIT, tried several saved configs, but even my oldest, which
isn't that old (new computer, didn't bother to copy over the older
configs from previous machine), exhibited the same problem.
Jeff,
It would appear that something is "stuck".
Do you have a saved configuration file from sometime before this problem
came up?
If so, try an EEINIT (Reset to Factory Defaults) and then restore the
configuration file.
The Reset to Factory Defaults will wipe out the calibration and
configura
Setting to “NOR” by a long press on Shift control should reset the passband, if
having it off center is what’s causing your issue.
Full disclosure, I don’t use SHIFT/WIDTH on SSB, so switching between the two
modes is not something I’ve done since building the radio in 2008 :-)
Grant NQ5T
K3 #2
Thanks, Grant, I'm not sure what you mean.
'shift lo'
short press shows 'FC 8 1.50' (expected when config:PB CTRL is set to .01)
long press works, I can set <--Norm-->, as does long press+left/right
(NORM1/NORM2)
'hi width'
short press shows 'BW 2.80' (expected when config:PB CTRL is set to .0
Did you try resetting the passband to "normal" by doing a long press on the
control?
Sent from my iPhone
> On Feb 23, 2016, at 3:31 PM, Jeff Schmidt wrote:
>
> I can no longer select low cut/high cut (vs. shift/width) in LSB/USB.
> A little homework reveals that this as a known side effect of
I can no longer select low cut/high cut (vs. shift/width) in LSB/USB.
A little homework reveals that this as a known side effect of changing
the passband shift from its default.
I'm sure I must have changed the PB CTRL to .01 at some point, but I
can't seem to change it back; a firmware reload d
7 matches
Mail list logo