No, actually, that's pin 10 not pin 11.
Bruce, N1RX
> AFAIK, the only 'downside' is that you need to run the separate PTT cable.
> Ron AC7AC
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http:/
U'
Cc: elecraft@mailman.qth.net
Subject: Re: [Elecraft] KPA500 AUX Cable Keying (DIGOUT1)
Thanks for the response, Ken. The rev B manual is not yet available for
download via the web page. I have built my own cable without pin 11
connected between the K3 and KPA-500. This raises the question then- w
On Wed, Jun 29, 2011 at 11:00 AM, Bruce Beford
wrote:
> Thanks for the response, Ken. The rev B manual is not yet available for
> download via the web page. I have built my own cable without pin 11
> connected between the K3 and KPA-500. This raises the question then- what ,
> if any, is the disa
control the PR6 preamp, while using the KPA-500?
Bruce, N1RX
_
From: Ken K3IU [mailto:kenk...@cox.net]
Sent: Wednesday, June 29, 2011 4:49 AM
To: Bruce Beford
Cc: elecraft@mailman.qth.net
Subject: Re: [Elecraft] KPA500 AUX Cable Keying (DIGOUT1)
Bruce:
Rev B of the Owner's M
Bruce:
Rev B of the Owner's Manual which came with my KPA200 shows
on page 18 that the DIGOUT1 line is maintained in the AUX
Cable. That was indeed the case with the one I received. I
broke off pin 11 in the connector so that I can continue to
use the DIGOUT1 signal to control my PR6 preamp.
7
I'd like some confirmation of this. I can see in the KPA500 manual (rev A,
page 16) that pin 11 of the AUX connector is INHIBIT#. That's fine. Pin 11
on the K3 AUX connector is DIGOUT1, OK. However, also in the KPA500 manual
(page 17), the wiring for a cable between the K3 and the KPA500 does not u
6 matches
Mail list logo