6
K2 4016
- Original Message -
From: "Fred Bennett" <[EMAIL PROTECTED]>
To:
Sent: Sunday, December 03, 2006 12:00 PM
Subject: RE: [Elecraft] Com port problem
I'm using the com cable that I made when I constructed the KIO2 and
I left out ALL but the standard RS232 connect
Thom,
Edgeport is the brand name. I have a good 4 port unit.
73,
Don W3FPR
> -Original Message-
> On Sun, 3 Dec 2006, Bill Steffey NY9H wrote:
>
> > i've been successful with used usb to serial edgeports
> very expensive
> > new
> > but very inexpensive on the "bay"site\
>
On Sun, 3 Dec 2006, Bill Steffey NY9H wrote:
i've been successful with used usb to serial edgeports very expensive
new
but very inexpensive on the "bay"site\
Some brand names might be of help.
Thom
www.baltimorehon.com/Home of the Baltimore Lexicon
www.tlch
Yes, the model I mentioned is a 4 Port device.
_
From: Stan Rife [mailto:[EMAIL PROTECTED]
Sent: Sunday, December 03, 2006 1:38 PM
To: Fred Bennett; elecraft@mailman.qth.net
Subject: RE: [Elecraft] Com port problem
Fred, that is way too much money for that adapter. I am getting
[EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Julian, G4ILO
Sent: Sunday, December 03, 2006 9:20 AM
To: elecraft@mailman.qth.net
Subject: Re: [Elecraft] Com port problem
I would not advise using any USB serial adapter with the KIO2. The KIO2
output is not a standard serial port. There is a
i've been successful with used usb to serial edgeports very
expensive new
but very inexpensive on the "bay"site\
bill
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber In
On Saturday 02 December 2006 17:51, Fred Bennett wrote:
> I just came back from the local electronics superstore with a USB to 2 port
>
> serial converter made by SIIG.
I bought a VSCOMM PCI dual serial card for a year old
compaq computer that had no serial ports. I had to
find a supplier on t
73deFred N9TA
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Julian, G4ILO
Sent: Sunday, December 03, 2006 9:20 AM
To: elecraft@mailman.qth.net
Subject: Re: [Elecraft] Com port problem
I would not advise using an
Fred,
Since the K2 works with one adapter but not another, look at the setup info
on both adapters - are the parameters similar? what are the differences?
Keep asking yourself questions like that until you either have it working or
decide to make that 3 hour round trip.
The K2 connects only the d
I would not advise using any USB serial adapter with the KIO2. The KIO2
output is not a standard serial port. There is an AUXBUS output on one of
the pins. I seem to recall that a few people have damaged their K2s by
using "standard" serial cables that had something else connected to this
pin.
Not all USB convertors are equal. Over the HRD website you will see
litany's of problems regarding them along with a recommended list of
compliant convertors. Unfortunately it sounds like the SIIG is one of those
that don't do their job properly. The reason it works with the 990 is their
levels
11 matches
Mail list logo