Hi Karl,
Yes, both check out fine with my MFJ-269
Thanks for the suggestion.
KARL MARDERIAN wrote:
Hi, n6xvt Karl.
1 is the cable from radio to dummy load good?
2 is the dummy load any good?
73 n6xvt
Sent from my iPhone
On Sep 22, 2009, at 6:41 PM, W4HDM w4...@bellsouth.net
Damon,
First, remove the KPA100 from the picture (remove it from the EC2
enclosure) and connect the KAT100 directly to the base K2 and see if it
works OK - if my suspicion is correct, it will.
If the KAT100 checks out, then check 2 things - first diodes D16 and D17
in the KPA100 and the short
Thanks Don I will do this now and post the results.
Don Wilhelm-4 wrote:
Damon,
First, remove the KPA100 from the picture (remove it from the EC2
enclosure) and connect the KAT100 directly to the base K2 and see if it
works OK - if my suspicion is correct, it will.
If the KAT100
Don,
Ok I removed the KPA100 and connected directly to the K2, I also tested with
2 different jumpers, as well as useing the RF in and the AUX connection. All
give the same results:
KAT100's relays sound and the K2 shows 1.0-1 swr. Lights on the KAT100 do
not light up on tune or TX.
K2 reduced
Hi, n6xvt Karl.
1 is the cable from radio to dummy load good?
2 is the dummy load any good?
73 n6xvt
Sent from my iPhone
On Sep 22, 2009, at 6:41 PM, W4HDM w4...@bellsouth.net wrote:
My KAT100 was working fine then developed a problem recently.
For those wondering what happened to my
Damon,
Thanks for removing the KPA100 from the picture, now we know the problem
is the KAT100 or the base K2. To eliminate the base K2 from suspicion,
test it into a dummy load and see if the HiCUR messages are still present.
While looking for solder problems, first check pin 1 of the KAT100
6 matches
Mail list logo