>> I would also like to be able to prompt for data input (as in "Please
>> enter desired diameter:") but I haven't found anything that appears
>> to support that in NGC. Could I do the data input prompt by calling
>> a shell script that would prompt for the data and replace the
>> variables in th
Paul Ritchie wrote:
> I have noticed that several of you were questioning whether EMC would
> work with a parallel port based upon PCI-e. I can assure you that it
> will, since the one built into the motherboard of my PC actually is
> PCI-e (there are no PCI slots in this PC at all, which is od
Thanks Chris,
I put in the comma and it worked...Just like the manual said!
Also thanks for the M0. I was going to put in a dwell but the M0 is
much more appropriate.
I probably wouldn't need the reminder at all except that I seem to be
getting a little stupid in my old age.
>>Does AXIS or any
Re: Low Cost Motion Contorl Card?
I have noticed that several of you were questioning whether EMC would work with
a parallel port based upon PCI-e. I can assure you that it will, since the one
built into the motherboard of my PC actually is PCI-e (there are no PCI slots
in this PC at all, which
Hi
I have question about how EMC2 controller compare with GE-FANUC
controller in perspective software hardware part of computation.
What is software?
What is hardware?
My understanding that EMC2 more relay on software and GE-FANUC more on
hardware.
In other ward there are difference between s
On Mon, Nov 12, 2007 at 10:58:54AM -0500, Cecil Thomas wrote:
> Does AXIS or any of the other displays support messages from .ngc or
> allow variable inputs.
>
> I would like to place something like (MSG "Be sure you have touched
> off before continuing this program")
> in my code.
Close. T
Does AXIS or any of the other displays support messages from .ngc or
allow variable inputs.
I would like to place something like (MSG "Be sure you have touched
off before continuing this program")
in my code. It would go along with a dwell to allow you to abort the
program if you had forgotte
If you have an arc that doesn't preview right, please post the code so
that it can be fixed in a future release.
If you can trim it down to just a few lines of g-code, just include it
in a message. Otherwise, e-mail me privately and attach the whole file
indicating where the problem is.
Thanks,
