On Sunday 22 January 2017 10:53:30 Ed wrote:
> On 01/22/2017 08:40 AM, Peter Blodow wrote:
> > Never touch a running system.
> > Peter
> >
> > Am 21.01.2017 20:24, schrieb Gene Heskett:
> >> Greetings everybody.
> >>
> >> My 3 jaw chuck atm, runs pretty true. But to be able to turn the
> >> facepl
On Sunday 22 January 2017 09:40:09 Peter Blodow wrote:
> Never touch a running system.
> Peter
>
Why not Peter, since it isn't yet running at a usable level?
My target of this particular exercise is to make, from 1/2" 7076 alu
plate about 60 yo, a double set of "drawbolt" clamped rings, one that
On 01/22/2017 08:40 AM, Peter Blodow wrote:
> Never touch a running system.
> Peter
>
> Am 21.01.2017 20:24, schrieb Gene Heskett:
>> Greetings everybody.
>>
>> My 3 jaw chuck atm, runs pretty true. But to be able to turn the
>> faceplate around and clean up the OD of the hub for a grab surface for
Never touch a running system.
Peter
Am 21.01.2017 20:24, schrieb Gene Heskett:
> Greetings everybody.
>
> My 3 jaw chuck atm, runs pretty true. But to be able to turn the
> faceplate around and clean up the OD of the hub for a grab surface for
> my clamp concoction so it can't unscrew itself durin
On Sun, 22 Jan 2017, Viesturs L?cis wrote:
> Date: Sun, 22 Jan 2017 16:12:23 +0200
> From: "[UTF-8] Viesturs L?cis"
> Reply-To: "Enhanced Machine Controller (EMC)"
>
> To: "Enhanced Machine Controller (EMC)"
> Subject: Re: [Emc-users] Unable to get 5i24 + 7i48 + 7i44 to work
>
> 2017-01-15
you should have power 5v between pins 4&5 and 7&8 of the rs485
pins 4&5 are gnd 7&8 are power , check your gnd in particular
if your drawing too much current you may not have 5v at this point
i tend to use external power directly to avoid any cable problems etc
On 22 January 2017 at 14:12, Vies
2017-01-15 18:10 GMT+02:00 Peter C. Wallace :
>
> Proper firmware for 7I48 and 7I44 is 5i24_16_svss6_8.bit
>
> NOTE: 7I48 on P4 (IO 0..23) , 7I44 on P2 (IO 48..71)
>
I got so far that manipulating pwmgen value pin does change voltage on
7i48 outputs, so that seems to be correct and working.
I am