On Wed, 29 Sep 2010 10:53:52 +0100, you wrote:
On 29 September 2010 09:32, Andy Pugh wrote:
Just put the various lines in your HAL file. Put the loadrt and addf
lines with the similar lines in the file, then put the rest anywhere
you want.
Thanks Andy - sorted now, works a treat. Only other
On 29 September 2010 09:32, Steve Blackmore st...@pilotltd.net wrote:
I'll try stepconf again, see if it's improved any and put's the other
required half in the hal file..
I would be surprised if it did.
There was also a fatal flaw in the hal code I posted; no source for
the speed signal.
On Wed, 29 Sep 2010 00:04:16 +0100, you wrote:
On 28 September 2010 23:48, Steve Blackmore st...@pilotltd.net wrote:
Is there any documentation for
spindle-rpm-filtered ??
No. It is a signal name, and the next paragraph says assuming that
spindle-rpm-filtered already exists
Yes, but the
Is there any documentation for
spindle-rpm-filtered ??
Saw it in on page 105 of the Integrator manual but can't find any other
reference in any of the manuals/
I hope it's what I need to stabilise the very twitchy speed display on
my panel.
Steve Blackmore
--
On 28 September 2010 23:48, Steve Blackmore st...@pilotltd.net wrote:
Is there any documentation for
spindle-rpm-filtered ??
No. It is a signal name, and the next paragraph says assuming that
spindle-rpm-filtered already exists
signal names (the first item in a net command) can be freely
Steve Blackmore wrote:
Is there any documentation for
spindle-rpm-filtered ??
Saw it in on page 105 of the Integrator manual but can't find any other
reference in any of the manuals/
I hope it's what I need to stabilise the very twitchy speed display on
my panel.
Here's what I did :
