Original-Nachricht
> Datum: Thu, 06 Sep 2007 00:17:41 -0500
> Von: Jon Elson <[EMAIL PROTECTED]>
> An: "Enhanced Machine Controller (EMC)"
> Betreff: Re: [Emc-users] Need advice on building a mill controller with EMC2
> Gerhard Pircher wr
Gerhard Pircher wrote:
>>Von: Jon Elson <[EMAIL PROTECTED]>
>
>>These are 14 W motors? That seems awfully small, even for a
>>desktop machine.
>
> Yeah, that's another problem. IIRC originally the machine was used to
> polish ceramic-like materials. I guess more powerful servo motors were
> not
On Wed, Sep 05, 2007 at 09:45:49PM +0200, Gerhard Pircher wrote:
> The Mesa card looks interesting. Do you use it with the SoftDMC Digital
> Motion Control Firmware?
With emc2, the "hostmot" firmware is used.
With "hostmot", emc sends velocity commands and reads encoder counts,
performing closed-
Original-Nachricht
> Datum: Wed, 05 Sep 2007 11:47:09 -0500
> Von: Jon Elson <[EMAIL PROTECTED]>
> An: "Enhanced Machine Controller (EMC)"
> Betreff: Re: [Emc-users] Need advice on building a mill controller with EMC2
> You might also take a look
gt; An: "Enhanced Machine Controller (EMC)"
> Betreff: Re: [Emc-users] Need advice on building a mill controller with EMC2
> Your setup sounds very much like my Anilam setups. Tach feedback to
> drives, encoder feedback to controller, +&-10V velocity command signal
> from
Gerhard Pircher wrote:
> Hi,
>
> I'm seeking for some comments about how to build a mill controller with
> EMC2, as I'm completely new to this topic.
> I got a 12 years old desktop mill, which was manufactured by KERN-
> Microtechnic [1]. The machine is in a very good condition, but some parts
> o
but the Mesa hardware saved me a good deal of $ and works
great.
RogerN
- Original Message -
From: "Gerhard Pircher" <[EMAIL PROTECTED]>
To:
Sent: Wednesday, September 05, 2007 5:46 AM
Subject: [Emc-users] Need advice on building a mill controller with EMC2
Hi,
Hi,
I'm seeking for some comments about how to build a mill controller with
EMC2, as I'm completely new to this topic.
I got a 12 years old desktop mill, which was manufactured by KERN-
Microtechnic [1]. The machine is in a very good condition, but some parts
of the original mill controller (a rac
