Try adding:
set interfaces reth0 encapsulation flexible-ethernet-services
I try to have a vlan 200 in layer 2 mode transparent accross the SRX in
failover
mode.
Is it possible to have a redundant interface as trunk link, with 1 vlan with
an
@IP, and 1 vlan in transparent mode.
I
I can't try this command because it's not accepted.
==
{primary:node0}[edit interfaces reth0]
xyz@AS-SRX650-01# set encapsulation ?
Possible completions:
ether-vpls-ppp Ethernet VPLS over PPP (bridging) device
ethernet-bridge
Mixed mode is not supported on an srx.
For a layer 3 ip you have to use an irb interface. This is non-routable so it
may not be what you're looking for. It's used for management of the device
typically. At best it's an ip to ping.
On May 31, 2012, at 12:59 AM, Per Granath
Flexible Ethernet services should be supported since 10.1.
http://www.juniper.net/techpubs/en_US/junos10.1/information-products/topic-collections/release-notes/10.1/topic-42298.html
It should allow you to mix, at least, 'inet' and 'vlan-vpls' on the interface.
Not sure if it will allow 'bridge',
I can tell you with certainty that if you try to configure bridge
(which required a reboot). If any other families other than bridge are
configured it will error out upon commit. Flexible ethernet services
does not include bridge. As of today mixed mode does not work on any
SRX series device.
I
The admin guides from juniper support portal are fantasticwhat do you
need to deploy and whats your design?
regards,
Muhammad Fahad Khan
JNCIE-M # 756, 2xJNCIP-(M SEC) # 834
Lead Network Consultant,
Global Technology Services, IBM
fa...@pk.ibm.com
+92-301-8247638
Skype: fahad-ibm
CLOSED CASE
In fact, it seems we can't config a trunk link with a interface vlan
layer 3 and a interface vlan layer 2.
The SRX650 can't accept the mixed mode.
Either you route your interfaces vlan layer 3 in the trunk link,
either you bridge your interfaces vlan layer 2 in the trunk link.
The
7 matches
Mail list logo