Try adding:
set interfaces reth0 encapsulation flexible-ethernet-services
I try to have a vlan 200 in layer 2 mode transparent accross the SRX in
failover
mode.
Is it possible to have a redundant interface as trunk link, with 1 vlan with
an
@IP, and 1 vlan in transparent mode.
I
I can't try this command because it's not accepted.
==
{primary:node0}[edit interfaces reth0]
xyz@AS-SRX650-01# set encapsulation ?
Possible completions:
ether-vpls-ppp Ethernet VPLS over PPP (bridging) device
ethernet-bridge
Mixed mode is not supported on an srx.
For a layer 3 ip you have to use an irb interface. This is non-routable so it
may not be what you're looking for. It's used for management of the device
typically. At best it's an ip to ping.
On May 31, 2012, at 12:59 AM, Per Granath
: [j-nsp] SRX650 - Failover - reth TRUNK with: vlan L2 mode
transparent, and vlan L3
I can't try this command because it's not accepted.
==
{primary:node0}[edit interfaces reth0]
xyz@AS-SRX650-01# set encapsulation ?
Possible completions:
ether-vpls
...@puck.nether.net] On Behalf Of roland DROUAL
Sent: Thursday, May 31, 2012 3:06 PM
To: juniper-nsp@puck.nether.net
Subject: Re: [j-nsp] SRX650 - Failover - reth TRUNK with: vlan L2 mode
transparent, and vlan L3
I can't try this command because it's not accepted
).
-Original Message-
From: juniper-nsp-boun...@puck.nether.net [mailto:juniper-nsp-
boun...@puck.nether.net] On Behalf Of roland DROUAL
Sent: Thursday, May 31, 2012 3:06 PM
To: juniper-nsp@puck.nether.net
Subject: Re: [j-nsp] SRX650 - Failover - reth TRUNK with: vlan L2 mode
transparent, and vlan L3
Hello the list,
I have 2 SRX650 in failover mode
There is reth0 in mode trunk, with vlan 954 and vlan 200 - (reth0 is
the interface outside)
There is reth1 in mode trunk, with vlan 100 and vlan 200 - (reth1 is
the interface inside)
I try to have a vlan 200 in layer 2 mode transparent
7 matches
Mail list logo