Hi again,
As many of you have read in recent weeks, I've been unable
to install 7.2 on my desktop machine, apparently because of
problems with the hard drive's partition table or something.
Today while in Winsucks, I ran some Norton AntiVirus and it
said I have one "master boot record", and two
M
Subject: [newbie] Installation woes
I'm trying to install Mandrake 7.0 on a Windows 95 machine with two HD's
and
a Cyrix 233 chip. It boots OK and gets to initialising the CD Rom but
always
falls over at
in second stage install
-X11 TransSocketUNIXConnect : Can't connect : errno =
PROTECTED]
Sent: Tuesday, May 30, 2000 12:24 PM
Subject: [newbie] Installation woes
I'm trying to install Mandrake 7.0 on a Windows 95 machine with two HD's
and
a Cyrix 233 chip. It boots OK and gets to initialising the CD Rom but
always
falls over at
in second stage install
-X11 TransSocketU
I'm trying to install Mandrake 7.0 on a Windows 95 machine with two HD's and
a Cyrix 233 chip. It boots OK and gets to initialising the CD Rom but always
falls over at
in second stage install
-X11 TransSocketUNIXConnect : Can't connect : errno = 111
-X11 TransSocketUNIXConnect : Can't connect :
I'm trying to install Linux Mandrake 7.0 on a Pentium MMX, 32mg RAM, 1.96Gig
hard drive, Yamaha sound and video card. I'm going for a Linux only install.
However, after the bootup and a bit of this and that... I get an error
message:
-X11TransSocket UNIX: can't connect error #111
Cannot
Last I heard Yamaha was totally UNSUPPORTED in Linux, although why they have
OPL3 drivers is beyond me???
What is your video card? Make/Model/RAM
HTH
Jaguar
[EMAIL PROTECTED] wrote:
I'm trying to install Linux Mandrake 7.0 on a Pentium MMX, 32mg RAM, 1.96Gig
hard drive, Yamaha sound and
Hi everyone,
I downloaded the Latest Linux Mandrake image and
burnt it to a CD. When I try to install it using any of the described
methods I get the following error:
PCI_IDE: unknown IDE controller on PCI bus 00
device 39, VID=1022, DID=7409PCI_IDE: not 100% native mode: will probe irqs
