abhash

you should use the numbers i the s-file. program foc can be used to calculate P and T from the s-file(s) and command focmec a by typing in the numbers.

jens

On Wed, 3 Apr 2013, Abhash Kumar wrote:

Hi,
    I have been using FPFIT to calculate focal mechanism and then used the
strike, dip and rake obtained from FPFIT to determine azimuth and dip of T
and P axis. I followed these steps:

 3  3 Nov 2011 16:26 36  L -13.741 -74.795100.6    0.9     TES   36  ? fpfit
  **** now locating with hyp as a preparation ***

 #    0  2011 11 3 1626 34.2 L -13.749 -74.760 94.3  TES 36 1.0

Type "hel" for information  on available commands.
 yes?    #      ORIGIN TIME         LOCATION         DEPTH    MAG   DDR DIP  RAKE CNVRG
  ---- ------------------- ------------------  -----    ---  ----- ---  ----
-----
    1 20  STN  DIST  AZ TOA PRMK HRMN  PSEC TPOBS            218   49 -109
 yes?  ================================

 Fit  0.000
 Errors in strike, dip and rake   10.0   5.0  18.0

I looked at the S-file and it has extra line after doing fpfit:
     128.0      49.0    -109.0 10.0  5.0 18.0  0.0  0.0           TES
FPFIT    F

Is that the first three numbers in the line above is strike, dip and rake of
fault plane ? It seems to me that the strike vlaue (128.0) given in the
Sfile is obtained after subtracting 90 from the DDR value (218) as
calculated during FPFIT. Do I need to add 90 to strike before I calculate
the azimuth of T and P axis or should I just use the three numbers written
in the S-file.

Thanks
Abhash kumar
University of North Carolina at Chapel Hill



_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

Reply via email to