Hi,
   I need to plot the P and T axis on stereonet to see if there is any
pattern in the orientation of stress. I used fpfit to calculate focal
mechanism and got the value for strike, dip and rake of the fault. I also
used foc to plot P and T axis in the beach ball diagram. Is there any way
to extract the numerical value of dip and azimuth of P and T axis, so that
I can further use it to make a stereographic plot. I would be extremely
grateful for help.

Thanks
Abhash kumar




On Thu, Apr 4, 2013 at 8:27 AM, Jens Havskov <[email protected]>wrote:

> abhash
>
> you should use the numbers i the s-file. program foc can be used to
> calculate P and T from the s-file(s) and command focmec a by typing in the
> numbers.
>
> jens
>
>
> On Wed, 3 Apr 2013, Abhash Kumar wrote:
>
>  Hi,
>>     I have been using FPFIT to calculate focal mechanism and then used the
>> strike, dip and rake obtained from FPFIT to determine azimuth and dip of T
>> and P axis. I followed these steps:
>>
>>  3  3 Nov 2011 16:26 36  L -13.741 -74.795100.6    0.9     TES   36  ?
>> fpfit
>>   **** now locating with hyp as a preparation ***
>>
>>  #    0  2011 11 3 1626 34.2 L -13.749 -74.760 94.3  TES 36 1.0
>>
>> Type "hel" for information  on available commands.
>>  yes?    #      ORIGIN TIME         LOCATION         DEPTH    MAG   DDR
>> DIP  RAKE CNVRG
>>   ---- ------------------- ------------------  -----    ---  ----- ---
>> ----
>> -----
>>     1 20  STN  DIST  AZ TOA PRMK HRMN  PSEC TPOBS            218   49 -109
>>  yes?  ==============================**==
>>
>>  Fit  0.000
>>  Errors in strike, dip and rake   10.0   5.0  18.0
>>
>> I looked at the S-file and it has extra line after doing fpfit:
>>      128.0      49.0    -109.0 10.0  5.0 18.0  0.0  0.0           TES
>> FPFIT    F
>>
>> Is that the first three numbers in the line above is strike, dip and rake
>> of
>> fault plane ? It seems to me that the strike vlaue (128.0) given in the
>> Sfile is obtained after subtracting 90 from the DDR value (218) as
>> calculated during FPFIT. Do I need to add 90 to strike before I calculate
>> the azimuth of T and P axis or should I just use the three numbers written
>> in the S-file.
>>
>> Thanks
>> Abhash kumar
>> University of North Carolina at Chapel Hill
>>
>>
>>
>>
_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

Reply via email to