abhash

output file from foc has P and T an dalso plots all P and T and makes a stress inversion.

jens

On Thu, 4 Apr 2013, Abhash Kumar wrote:

Hi,
   I need to plot the P and T axis on stereonet to see if there is any
pattern in the orientation of stress. I used fpfit to calculate focal
mechanism and got the value for strike, dip and rake of the fault. I also
used foc to plot P and T axis in the beach ball diagram. Is there any way to
extract the numerical value of dip and azimuth of P and T axis, so that I
can further use it to make a stereographic plot. I would be extremely
grateful for help.

Thanks
Abhash kumar




On Thu, Apr 4, 2013 at 8:27 AM, Jens Havskov <[email protected]>
wrote:
      abhash

      you should use the numbers i the s-file. program foc can be used
      to calculate P and T from the s-file(s) and command focmec a by
      typing in the numbers.

      jens

      On Wed, 3 Apr 2013, Abhash Kumar wrote:

            Hi,
                I have been using FPFIT to calculate focal
            mechanism and then used the
            strike, dip and rake obtained from FPFIT to
            determine azimuth and dip of T
            and P axis. I followed these steps:

             3  3 Nov 2011 16:26 36  L -13.741 -74.795100.6
            0.9     TES   36  ? fpfit
              **** now locating with hyp as a preparation ***

             #    0  2011 11 3 1626 34.2 L -13.749 -74.760 94.3
            TES 36 1.0

            Type "hel" for information  on available commands.
             yes?    #      ORIGIN TIME         LOCATION
            DEPTH    MAG   DDR DIP  RAKE CNVRG
              ---- ------------------- ------------------
            -----    ---  ----- ---  ----
            -----
                1 20  STN  DIST  AZ TOA PRMK HRMN  PSEC
            TPOBS            218   49 -109
             yes?  ================================

             Fit  0.000
             Errors in strike, dip and rake   10.0   5.0  18.0

            I looked at the S-file and it has extra line after
            doing fpfit:
                 128.0      49.0    -109.0 10.0  5.0 18.0  0.0
            0.0           TES
            FPFIT    F

            Is that the first three numbers in the line above is
            strike, dip and rake of
            fault plane ? It seems to me that the strike vlaue
            (128.0) given in the
            Sfile is obtained after subtracting 90 from the DDR
            value (218) as
            calculated during FPFIT. Do I need to add 90 to
            strike before I calculate
            the azimuth of T and P axis or should I just use the
            three numbers written
            in the S-file.

            Thanks
            Abhash kumar
            University of North Carolina at Chapel Hill





_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

Reply via email to