Pat, On bore-thru I add an additional clamp behind RK's puller, I use the Pro Metal Vice Clamp from GS #8288 with a wide body screw clamp that I made. I found that by adding twice the clamp surface, you can pull almost any standard head with very little heat, and the bore-thru's with about the same heat that you need for a standard head with one clamp. I use a mini butane, heat the head, add a little tension, wait 1 minute, reheat and pull the head, Hope this helps.
George Huson ByGeorge Custom Clubs --- [EMAIL PROTECTED] wrote: > $10 to pull and save the shaft? I just finished > pulling the head and I have to tell you that ranks > up there with the 975's as one of the most difficult > heads to pull. I am still having problems with the > shaft slipping through the rubber clamp on Kennedy's > puller. I guess I just don't have enough confidence > to apply the pressure needed without the fear of > smashing the shaft. $110 sounds reasonable enough. > Thanks for your quick responses. > Pat McGoldrick--On Target Golf > [EMAIL PROTECTED] > > --- Original Message ----- > From: [EMAIL PROTECTED] > To: [EMAIL PROTECTED] > Sent: Wednesday, September 24, 2003 8:55 PM > Subject: Re: ShopTalk: FUJIKURA RESHAFT > > > In a message dated 9/24/03 4:03:03 PM Pacific > Daylight Time, [EMAIL PROTECTED] writes: > > > > > I have a customer that wants his GBB II > reshafted with a Vista Pro 60 shaft, could someone > give me some kind of indication of the going rate > for a reshaft with this shaft? This will be my first > reshaft of the GBB II and my first experience with > any Fujikura shaft. TIA > Pat McGoldrick--On Target Golf > [EMAIL PROTECTED] > > > > Hi Pat, > I charge $10.00 for the pull, $70.00 for the > shaft, $19.00 on the build including spineing and > flowing, and $10.00 on the bore thru, so that's > $109.00, if they just want it stuck with the logo up > or down without spineing and flowing the build is > $9.00 instead of $19.00. > David >