Many Thanks Guy's !!!!
----- Original Message -----
Sent: Saturday, April 30, 2005 9:35
PM
Subject: Re: ShopTalk: Taper Tip or
Parallel?
Tflan is right, its the same for steel or graphite. I've done a number of
sets and the dremel
is the way to go. Any Pings I'm aware of are taper.
Beg
to disagree. Callaway's are a strange breed. The very bottom of the
hosel at the sole is a little smaller diameter than the rest of the
hosel bore. Notice that all the Callaway tips are slit . . . three
crossways cuts . . . across the bottom of the tip. The tips are shoved
into the hosel and a plastic plug is hammered in, expanding the slits
against the hosel wall. Sort of a built-in shim. The process can be
matched by slitting a tip with a dremel tool, or the bottom of the hosel
can be bored out and a standard .370" tip shaft can be
inserted.
In either case, the shafts are not taper
tip.
TFlan
----- Original Message ----- From: "comgolf"
<[EMAIL PROTECTED]> To: Sent: Saturday,
April 30, 2005 8:32 AM Subject: Re: ShopTalk: Taper Tip or
Parallel?
> The Callaways are ta! per tip. > > I
also have the same question for the Ping I/3 irons....... as I
haven't > re-shafted any of these till now. > >
MTIA > Jay > > ----- Original Message ----- > From:
"Greg Zachmann" <[EMAIL PROTECTED]> > To:
> Sent: Saturday, April 30, 2005 11:10
AM > Subject: ShopTalk: Taper Tip or
Parallel? > > >> I haven't worked with the Callaway X
16 irons and wanted to verify that >> these are taper
tip. >> >> TIA, >> >>
GregZ >> >> >> >> >> > >
Carl Mc Kinley Retired, PCS Certified
Class 'A' Clubmaker (Life Member) GCA Accredited
Clubbuilder [EMAIL PROTECTED]
P T Barnum is the patron saint of
expensive club manufacturers.
__________________________________________________ Do You
Yahoo!? Tired of sp! am? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
|