Re: ShopTalk: Taper Tip or Parallel?

[jhm]

Title: Re: ShopTalk: Taper Tip or Parallel?

Jeremy:

I assume you're not setting up a high volume shop to handle Callaway reshafts. I did a set using TFlan's instructions and parallel tip graphite irons as Tflan mentioned and used a small hacksaw to cut the slits. It worked great. Takes some time to do it with the hacksaw but you don't have to worry about removing as many fingers in the process as with a dremel.

John

shoptalk

clubmaker-online.com

Can you use a small hacksaw to slit the tips?
Jeremy.

comgolf wrote:

Many Thanks Guy's !!!!

----- Original Message -----

From: Carl McKinley

To: ShopTalk@mail.msen.com

Sent: Saturday, April 30, 2005 9:35 PM

Subject: Re: ShopTalk: Taper Tip or Parallel?

Tflan is right, its the same for steel or graphite. I've done a number of sets and the dremel

is the way to go. Any Pings I'm aware of are taper.

 

Carl

tflan <[EMAIL PROTECTED]> wrote:

Beg to disagree. Callaway's are a strange breed. The very bottom of the
hosel at the sole is a little smaller diameter than the rest of the hosel
bore. Notice that all the Callaway tips are slit . . . three crossways cuts
. . . across the bottom of the tip. The tips are shoved into the hosel and a
plastic plug is hammered in, expanding the slits against the hosel wall.
Sort of a built-in shim. The process can be matched by slitting a tip with a
dremel tool, or the bottom of the hosel can be bored out and a standard
.370" tip shaft can be inserted.

In either case, the shafts are not taper tip.

TFlan

----- Original Message -----
From: "comgolf"
To:
Sent: Saturday, April 30, 2005 8:32 AM
Subject: Re: ShopTalk: Taper Tip or Parallel?


> The Callaways are ta! per tip.
>
> I also have the same question for the Ping I/3 irons....... as I haven't
> re-shafted any of these till now.
>
> MTIA
> Jay
>
> ----- Original Message -----
> From: "Greg Zachmann"
> To:
> Sent: Saturday, April 30, 2005 11:10 AM
> Subject: ShopTalk: Taper Tip or Parallel?
>
>
>> I haven't worked with the Callaway X 16 irons and wanted to verify that
>> these are taper tip.
>>
>> TIA,
>>
>> GregZ
>>
>>
>>
>>
>>
>
>

Carl Mc Kinley Retired,
PCS Certified Class 'A' Clubmaker (Life Member)
GCA Accredited Clubbuilder
[EMAIL PROTECTED]

P T Barnum is the patron saint of expensive club manufacturers.

__________________________________________________
Do You Yahoo!?
Tired of sp! am? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com

---

No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.11.1 - Release Date: 02/05/2005
 

-- 

Thanks!
John Muir
http://clubmaker-online.com
http://gripscience.com
http://elevongolf.com
810.923.7396