JD loves your hydraulic puller and I got your GS grip removal tool. My son bought Ping i20's 'Black Dot' in LH used 2 rounds. His previous gamer irons were the Mizuno MP-30 from 2004 which he used to set a course record '64'.
Ping i20 4-iron is so easy to hit. Too soft a flex at Stiff. I need to ream the heads and install standard weight X+ flex parallel tipped steel with his set fully 'balanced & blueprinted'. Top of hosel under black ferrule is flat not angled like many other Ping designs. I've never reamed out a Ping iron head with its harder 17-4 SS. Does this pose any problems I need to be aware of? I will use a carbide tipped reamer at 200 rpm and RWK's hosel reaming vice. Kind regards, Harry ------Original Message------ To: ShopTalk@mail.msen.com Cc: j...@gtagolfers.com Subject: ShopTalk: Clubmaking stuff for sale Sent: May 31, 2012 5:24 PM Your welcome Jen. I was certain JD would buy your shaft puller once he seen your post which I sent his way. Anyway good luck with what life deals you down the road. Kind regards, Harry ------Original Message------ From: Jen Kuntz Sender: owner-shopt...@mail.msen.com To: ShopTalk@mail.msen.com ReplyTo: ShopTalk@mail.msen.com Subject: Re: ShopTalk: Clubmaking stuff for sale Sent: May 31, 2012 9:39 AM Thanks to TFlan for not changing; thanks to HFS for forwarding my email to a friend of yours - the puller is tentatively sold now, thank you very much; and thanks to whomever suggested trying Toronto Golf Nuts or a similar forum, didn't think about that (I deleted the email you sent but you know who you are!). I'll stick around a few more days in case someone replies to the list but anyone who is interested has my email address to reach me after I unsubscribe. Thx Jen On 30/05/2012 12:54 PM, Tom Flanagan wrote: So, doing anything later? :-) TFlan Sent from BlackBerry device Visit Site: www.GolfDNA.comJ)µ©dJ'²Þu¼ éÞÀ ]V¢h ·®y¨æÛiÿö¥v)Z¾¢(