On Wed, 17 Mar 2010 21:43:47 +0000 (UTC) Cry <[email protected]> (C) wrote:
C> Petr Vanek <van...@...> writes: C> C> > the SHR manual receiver a lot of tlc, please do use it before C> > asking questions that have been answered many times before: C> > C> > http://wiki.openmoko.org/wiki/SHR_User_Manual#Power C> C> Note that that page is not helpful. If the settings aren't C> persistant, there is little value in me using the gui to set them. C> Then there is a bunch of information about the OLD way to do it. yes, with a note that it is old. C> Then there is an almost content free block about the new way which C> just points you to empty? not sure what you mean. C> C> /etc/freesmartphone/conf/GTA02/fsodeviced.conf C> C> but that file has a COMPLETELY EMPTY power control block. The /etc/freesmartphone/conf/GTA02/fsodeviced.conf is not empty by default, so it had to be erased. there is an example section in the manual. C> kernel_idle block has some stuff but are those entries explained? C> What is a prelock? Which field turns it all off? Is kernel_idle C> the right thing? as said above, there is an example config and the timeout sequence is also described in the manual, actually in the same section. C> I don't want to idle the kernel, I want to idle my freerunner. C> C> This is the problem with the tutorial. It doesn't tell a story. there are only problems where we want to see them. take it easy buddy Petr _______________________________________________ Shr-User mailing list [email protected] http://lists.shr-project.org/mailman/listinfo/shr-user
