>
> There has been a some postings about limiting current flow to
get smaller
> particles in the past.

It is likely that the increase in particle size has more to do
with the inclusion in the colloid of residue build up rather than
the actual current level. Brooks Bradley has reminded me about
his previous post of the many tests his research body has
conducted in this area, the results showing no difference in
particle size for voltages up to 60 Volts or currents up to 20
mA, using their generating configuration. This configuration
includes a method of keeping the solution in a gentle aggitation,
in order to keep the silver ions spread throughout it.
Residue build up is higher at higher current levels and the
factors that influence this are voltage, time, and aggitation.
Most people who have problems with cloudy colloids which turn
dark are most likely generating for too long a time, are not
stirring the solution, or have poor quality water or contaminated
containers.

> Experience has shown me that even as little as 27VDC does
produce larger > particles, when using non distilled water of any
kind. But voltage doesn't
> cause it, current flow it the problem.
>
> Would limiting the voltage, say to 12VDC, reduce current flow?
Would it be
> best to start with 27VDC and then reduce the voltage as current
flow begins
> to increase, like you can do with a light bulb to increase and
decrease the
> brightness?

Limiting voltage does indeed reduce the current flow and your
idea above would work admirably. However I have found that using
12 Volts from start to finish eliminates many of the problems
discussed above, ie residue build up, because the current flow is
very low, especially if the electrodes are kept a couple of
inches apart. In the configuration, which I have posted to the
list in the past, the current reaches only 1mA or so.

Most configurations will work fine, or in Brooks words, "As a
point of information:  we have found that it is VERY DIFFICULT to
avoid making very good solutions.  We use 36 VDC quite frequently
and with splendid results."
as long as one stirs frequently and does not generate for too
long.

> If I remember correctly there was some postings on monitoring
the process
> until it reached a set milliamps. What if we could control the
current flow
> at an optimal level? Would we be able to produce small particle
high PPM
> batches even with LVDC units?

That should be possible, however each set up will be different as
the electrode configuration directly affects the current draw.

> (Was I the one that said we were making things to complicated?)
:-)
>
> Still I think Mike has an exciting idea.
>
> To bad I don't know much about electricity.
>
> I too would like to see a discussion on this "limiting current"
in relation
> to how it can be done on the simple low voltage units.
>
> Once a person knows how to limit current it should work equally
well with
> distilled or non distilled water.

True, but the CS in non-distilled water will contain compounds
other than CS.

> Then, of course, will come the questions of how much current
limiting should
> be done, as we seek the optimal levels, and the time increase
for making a
> batch.  But that is the cost of progress and, in my view, one
of the reasons
> for this list.
>
> Sadly, as Mike has said, we have lost many of our high tech
members, but I
> think there are enough minds still on to tackle this.
>
> Larry

Regards - Ivan



--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>