bober...@swbell.net wrote: > > Hi Ya'All, > > It's pot stirring time again. > > The day of predictable CS is here!!!!!!!!!!!!!!
Ah, addressing an issue I am still trying to understand! > After dozens of tests with the polarity switching scheme, if one knows > the initial current at the beginning of the brew operation, then the > cell current will follow a predictable curve and so will the PPM. Can you elaborate? Formula or charts? I'm new to this, so pardon if the question is ignorant, but doesn't the the surface area of the electrode in solution figure in? I would guess that the emitted silver for any surface area could be normalized though (surface area * current or something like this?). > I am ordering a few parts tomorrow to build the prototype, and > everything you need to build it will be detailed by the end of next > week. It will use a 555 timer and a new very low current DPDT relay. The > timer and relay will be driven by 4 batteries of your choice AA, C, or > D; two diode, four resistors, one electrolytic cap., a circuit board, > plus several small connectors and battery box. You can package it anyway > you want. I am assuming that the relay is for alternating the polarity to the electrodes here (other than evening out the wear on the electrodes, is there a point to this?). An "H Bridge" might be more efficient and less succeptable to fail over time than a mechanical relay?! > This will put a stop to all of the questions as to why "my CS turns > color," and what is my ppm. You really have to "screw-up"to get yellow. Again, I'm pretty new to this, is there a FAQ somewhere that might explain why ending up with the yellow color is not a good thing? While I am still a long way from finalizing the design :-). I'm thinking about a microcontroler that would deal with temperature of solution (this seems like an important value in the equation) and control of time, voltage (maybe) and current. Even with all I have read on this to date, I don't see how one gets any degree of consistancy with the methods and equipment that I've seen recommended / being used. Granted, again, I am new to this. I do have some experience with industrial process control and maybe I am trying to make this more difficult than it need be, but I have a hearty respect for "making medicine" that I am going to put into either myself or someone I care about :-). I've seen the abandon with which the "conventional medicine establishment" seems to dispense meds and the results :-(. Paranoid? I'm not sure yet :-), further research is required :-). Thanks & take care, Vikki. -- Victoria Welch, WV9K, DoD#-13, Net/Sys/WebAdmin SeaStar.org, vikki.oz.net "Walking on water and developing software to specification are easy as long as both are frozen" - Edward V. Berard. Do not unto others, that which you would not have others do unto you. -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: silver-list-requ...@eskimo.com -or- silver-digest-requ...@eskimo.com with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: silver-list@eskimo.com List maintainer: Mike Devour <mdev...@id.net>