James,
go here :
http://www.tannerm.com/electrochemistry/ion_speeds/IonSpeeds.htm

Sorry about the math :-/
I don't know who could conduct these measurements, but Zeta
potential can be measured in a similar manner. Its a matter of
timing the migration of an ion across a field as viewed under a
microscope and then plugging the numbers.

This looks interesting also:
http://www.che.wsu.edu/modules/berquist/electrophoresis.html
but may not be of much use.

Yes spectrophotometry should work, once calibration has been
established. I have made a small immersible unit which uses an
RGB led and photodiode, but which is not of much use in
definitive measurement until I can find a cheapish way to
establish particle size.

A non-antibiotic drug habit is whole lot more fun too, so I've
been told...

Cheers - Ivan


----- Original Message -----
From: James Osbourne, Holmes <[email protected]>
To: <[email protected]>
Sent: Tuesday, 31 August 1999 10:03
Subject: RE: CS>Ion size was buying CS


> Good stuff Ivan...
>
> Could you direct me to basic info on "The electrophoretic
method may be a
> better way to determine particle size,..."  I have seen the
term but cannot
> recall how it works.  How does the price compare with
TEMs?---tests, of
> course, not the instrument.
>
> Also, Bob Berger said that one method of determining particle
size is to
> measure absorption in the UV range with a Spectrophotometer.
> Are you familiar with that technique?  If I can get TEM pix of
my size, I
> might be able to correlate that with UV Spec. readings in some
rough sort
> of way...enough to verify that I am producing a good sol.
Perhaps.
>
> Of course that means buying a new tube and filter for the old
Spectronics
> 20.  Sometimes I think it would be easier to have a
non-antibiotic  drug
> habit...
>
> James Osbourne, Holmes
>
> [email protected]
>



--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>