On Apr 29, 2012, at 9:26 AM, zzekel...@aol.com wrote:
In a message dated 4/29/2012 10:37:43 A.M. Eastern Daylight Time, bbane...@earthlink.net writes: How does one receive instruction in the technique? Are there..."studies"? Thank you for that info. Hi Jim, I used it & let Bg know on the electricgermkiller sit.--It was put in the archive with my instructions. She asked for pictures of how I built it but I never took any & sent them..I should but it is so easy-----I took about 6-8 inches of lamp wire---pulled it in half----cleaned the rubber / plastic on each end of both wires-- { about 3/4 inches } I soldered one end of one wire to the pos. post on the battery & one end of the other wire on the negative end.... On the other bare ends I wrapped a small piece of cotton cloth. { I used a needle & thread to keep it in place | I soaked the cloth end of each wire in distilled water-----Put the cloth end of one wire in my mouth as close to the abscess as I could get it & the other wire outside on the big bump on my jaw......I help them in place for 5 mins. then switched positions ---inside wire out * outside wire in {thus changing the polarity } & held it for 5 mins. ..... I did this in the evening before bed time..rinsed my mouth with hydrogen peroxide / distilled water & then CS /EIS... I did the same thing the next morning & again in the evening....The next morning when I got up the swelling was almost gone & no more problems since...This was several months ago....NO- you can't feel a thing as far as electric current passing through the jaw... I even used it to cure my Grandson's cold sore & an infected big toe.... Good luck--Lois
