Hey Guys,
so - I want to get a meter to measure the current in the water at the
beginning of my run and at the end. Am I correct in assuming that if I do
that -- and also make sure I use the same setup and same ppm water that then
I can standardize my process so that if I get my cs tested I will know
approximately what ppm I am making ? I ordered a PWT meter - but what kind
of meter do I get to check the current - or is it resistance? Pardon me but
technical stuff is a real challenge for me. my brain just turns off.Bill
suggested I get a volt-ohm  meter from radio shack that reads in the
milli-ohms range. Someone else, I think Chuck - said one should get a
digital multimeter from Radio shack. Are they the same thing? I would like
to get only one more meter and be done with meter buying -- is there
anything else that I am likely to need?

Thanks so much  -- and I'm sure I'll be coming to you guys for help in using
these damn things once Î get them.
with resistance :-)
Katarina


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>