## Only true if no current controls are used, otherwise, current stays the same or less no matter what the conductivity. KD'C
On 05/15/00, James Osbourne, Holmes wrote... > >Increasing TDS in start water causes increasing currrent, and can cause >larger particles. Marx says 0.8 PPM TDS is optimal for his HVAC process. > >-----Original Message----- >From: Ted Windsor <[email protected]> >To: [email protected] <[email protected]> >Date: Saturday, May 13, 2000 11:39 AM >Subject: Re: CS>Silver - an article > > >>My experience has been that it depends on the quality of water used. >>For example I distill my own water and have never had amber or yellow >>CS, mine has always been clear. Yet people who use the same unit and >>have purchased commercial distilled water have told me their CS is amber >>in color? >> >>Blessings >>Ted >> >>James Allison wrote: >> >>> Personally? I've always liked and agreed with what Peter A. Lindemann >>> says about color: "There has been a fair amount of controversy in the >>> public literature concerning the appearance of the "yellow" color. A >>> lot of well meaning people have told me that "yellow is bad", "silver >>> isn't yellow", "yellow is sulfur contamination", "yellow is iron >>> contamination", and lots of other things. I finally found what I >>> believe to be the answer to this question in a book titled Practical >>> Colloid Chemistry, published in London in 1926. In the section on the >>> "Colours of Colloidal Metals", sub-section on the "Polychromism of >>> silver solutions" on page 69, I found the following statements: "The >>> continuous change in colour from yellow to blue corresponds to a >>> change in the absorption maximum of the shorter to longer wave-lengths >>> with a decreasing degree of dispersion. This is a general phenomenon >>> in colloid chemistry illustrating the relation between colour and >>> degree of dispersion." This section goes on to describe the colors >>> that show up in a wide variety of colloidal metal solutions. >>> Interestingly, they ALL have a yellow phase. For true >>> "electro-colloidal" silver, the particle size range that can appear >>> yellow is .01 to .001 microns (10 to 100 angstroms) because that is >>> the size of silver particle that best absorbs the indigo light, >>> leaving only its inverse color, yellow, to be observed. The final >>> transparent-yellow appearance only shows up after the particles have >>> become evenly dispersed." Yours in health, >>> James Allison ---------------------------------------------Allisons >>> Apothecary - Your On-Line ApothecaryVisit Us Soon - >>> http://allisonsapothecary.comHome of the $39.95 Colloidal Silver >>> GeneratorAnd Wonderful Prices On Quality Products LikeMSM, Ionic >>> Mineral Waters and Apricot >>> Kernels--------------------------------------------- >>> >>> ----- Original Message ----- >>> From: [email protected] >>> To: [email protected] >>> Sent: Saturday, May 13, 2000 9:05 AM >>> Subject: Re: CS>Silver - an article >>> Sounds suspicious to me. Mine is crystal clear. >>> >>> >>> -- >>> The silver-list is a moderated forum for discussion of >>> colloidal silver. >>> >>> To join or quit silver-list or silver-digest send an e-mail >>> message to: >>> [email protected] -or- >>> [email protected] >>> with the word subscribe or unsubscribe in the SUBJECT line. >>> >>> To post, address your message to: [email protected] >>> Silver-list archive: >>> http://escribe.com/health/thesilverlist/index.html >>> List maintainer: Mike Devour <[email protected]> >>> >> >> > > >
