In a message dated 6/22/00 8:54:57 AM EST, [email protected] writes:

<< 'm not sure that the two can be compared Roger. I imagine that having
 too high a frequency across submerged electrodes would impede the
 dissolution of the silver, as the ions would be sucked back onto it in
 short order, if they managed to escape at all (pure speculation).
 I'll leave it at that!

 In your situation, plasma arc, I think the opposite is true. The
 frequency would serve to moderate what could otherwise be uncontrolled
 melting of the electrode and inferior outcomes. I have welded stainless
 steel for years using the gas tungsten arc method, and my present welder
 has a pulse feature adjustable to 10KHz (I think) and this is used to
 control the amount of heat entering the work and the size of the weld
 pool.
 At low frequencies (below RF) there would be no effective difference, as
you are dealing primarily with resistance (water bulk). In the welder, you
may have a pulsed mode (DC pulse width control to reduce power) or if
AC then the series limiting reactor would have a drop in impedance as the
frequency was raised, increasing the power out with frequency!
 Ivan
  >>
At 11:51 AM 6/22/2000, you wrote:
Ivan: Very interesting point about controlled melting. If there is one thing
that characterizes my HVAC sputtering process is that I have excellent
melting control.

Thanks,

Roger

Because you have very limited current,  a fraction of 1 percent of welding!
In welding you need to melt more then the tip of the electrode plus heat
the substrate! The bulk resistivity of the water (plus your transformer
reactance) provides a very low controlled current! A higher frequency would
not change much on your setup!

Re: Hanna the PWT:
As I recall in measuring my PWT output, it had a 6khz square wave
and a very low voltage like 40-50mv RMS! The combination of the two
limit plate out effects. There is not enough voltage to release ions of
metal from the electrodes!

[email protected]