On Mon, 20 Nov 2000, russ e rosser wrote: > Yes. Try them & see; let us know what works. > > Although current is the danger, voltage pushes the current. The > (unlikely but possible) danger of a transformer shorting is the sudden > jump from 9-12 to 115V, which would multiply the current commensurably. > Batteries couldn't do that; their max. voltage is fixed. You should > determine empirically what voltage with your particular body resistance, > current tolerance, etc.
The transformer is not likely to short out in a fashion that would cause it to have 115 V between the two ends of the secondary winding that normally output 9-12 v. The danger is a short circuit between some point on the primary winding to some point on the secondary. If the defective point on the primary is near the hot side of the AC line, then both ends of the secondary will be perhaps 115V above ground, and if a person in contact with the secondary voltage via hand held probes is also in contact with ground, a possibily letal shock would result. It doesn't matter which point on the secondary winding the primary is shorted to. If the top of the primary were to short to the middle of a 10V secondary winding, there would still be 10V between the two probes, but one would be 110V above ground and the other would be 120V above ground. Either would kill. If the short circuit were to the middle of the primary winding, then the secondary winding would be 55 V or so above ground, still dangerous in some conditions. Because the danger is a primary to secondary short, there is no way to protect with MOV's across the windings. If the supply is equiped with a 3 wire plug, connecting one side of the secondary winding to green wire safty ground, and having proper sized fuses in both sides of the primary winding would provide a great amount of protection. Using a style of power transformer where the winding bobbin is divided providing a solid plastic barrier between the primary and secondary is also good, but beyond the control of those using wall warts. The above discussion is written as if the user is holding paddles directly connected to the transformer secondary winding: in a real circuitry, the secondary winding goes through a diode bridge to become DC voltage, then to circuitry to produce the desired pulses, but none of that will provide isolation which would protect the user from the danger of a shorted transformer. I'll stick to battery designs, myself, although the risk of a quality transformer failing is extremely low. If it weren't for bad luck, I wouldn't have any luck at all. John > > On Tue, 14 Nov 2000 22:19:11 -0600 "John Draper" <[email protected]> > writes: > > > > Russ, > > > > Thank you for the information. I have access to Beck's Gray's > > anatomy > > diagrams. > > > > One question though comes to mind right now is, couldn't a person > > use > > batteries instead of a tranformer to avoid risk of electrocution? If > > so, > > what is the voltage required? > > > > Thanks, > > > > John > > > > > > ----- Original Message ----- > > From: "russ e rosser" <[email protected]> > > To: <[email protected]> > > Cc: <[email protected]> > > Sent: Tuesday, November 14, 2000 9:01 PM > > Subject: Re: DC accross lymph nodes modality > > > > > > > If you make these, be advised of the "current" discussion: It's > > not > > > impossible for a transformer to short input power to the leads. > > In this > > > unlikely event, you could die painfully. One of the posted > > suggestions > > > for limiting the current should probably be incorporated > > imminently. > > > Wherever the sponges contact the body, current will pass between > > them. > > > Beck included a lymph node chart from Gray's Anatomy with his > > blood > > > boxes. I have a new edition but no scanner; let me know if you > > need a > > > photocopy... > > > > > > --Russ > > > > > > > Hi Russ, > > > > > > > > Please explain the procedure you use of putting DC accross lymph > > > > nodes to > > > > create cleansing reactions and also nullifying deep dental > > > > infections with > > > > LVDC - I'm interested in both of these. > > > > > > > > Thanks, > > > > > > > > John > > > > > > > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > To join or quit silver-list or silver-digest send an e-mail message to: > [email protected] -or- [email protected] > with the word subscribe or unsubscribe in the SUBJECT line. > > To post, address your message to: [email protected] > Silver-list archive: http://escribe.com/health/thesilverlist/index.html > List maintainer: Mike Devour <[email protected]> > >

