Hi Russ,

On Tue, 21 Nov 2000 19:02:31 -0600, russ e rosser
<[email protected]> wrote:

>Very enlightening, but would any of this apply to 'wall warts', which
>never have a 3rd prong?  --Russ

No, most GFI's don't work with 2 prong devices, as far as I know.
It's certainly possible to design a GFI that does.

But, as I mentioned in another message, putting 115 volts AC across
the normal zapper circuits will instantly fry the transistors or IC in
the circuit -- and won't put 115 volts across the wands (but ... you
could have 115 volts on both wands, and touching something else that
was grounded could kill you).

HOWEVER!!, the original Beck circuit used relays to switch the 30
volts from the power supply -- and would easily pass 115 volts to the
pads.  Tom Miller's bioelectrifier used opto-couplers, which could
also allow deadly voltage across the pads (the opto-couplers have a
voltage rating of about 80 volts, so would take a few cycles to blow
-- about 1-2 seconds).

Of course, if either of the above devices used a power supply that had
a current limiter and a crowbar over-voltage circuit, then they'd be
okay.

Also, I've never seen a wall-wart to fail by putting out high voltage
(I have hundreds of them) -- they've never let the smoke out of
equipment they're powering.  If they fail, they won't put out
anything.

-- Dean -- from (almost) Duh Moyn  (CDP, KB0ZDF)


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>