Chuck, I am curious as to what it is about my post that your so strenuously object to? Did you read the entire thread? Best Regards, Arnold Beland
----- Original Message ----- From: <[email protected]> To: <[email protected]> Sent: Saturday, June 08, 2002 10:17 PM Subject: Re: CS>Re CS > Strange phenomena > No,No,No,NO! > Use a 1000 ohm resistor in series with one lead, and measure the VOLTAGE across > it. As per ohms' law the reading will directly interpret as milliamps. > No additional current is contributed to the circuit. > > Chuck > Nurse: "Doctor, the man you just gave a clean bill of health to dropped dead > right as he was leaving the office". > Doctor: "Turn him around, make it look like he was walking in." > > On Sat, 8 Jun 2002 14:10:10 -0400, "Arnold Beland" <[email protected]> > wrote: > > >If you are using a multimeter on the ohms range to measure the conductivity > >of your solution you may be putting yourself in harms way. These meters use > >a DC source voltage for resistance measurements, usually a 9 volt battery. > >This is enough voltage to start the process of electrolysis from one probe > >to the other. I believe that most of these probes are nickel plated. > >Nickel ions are very bad for you. A proper conductivity meter uses a > >relatively low AC voltage at 400 cycles ore more to eliminate the very > >phenomena. > >Best Regards, > >Arnold Beland > > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > Instructions for unsubscribing may be found at: http://silverlist.org > > To post, address your message to: [email protected] > > Silver-list archive: http://escribe.com/health/thesilverlist/index.html > > List maintainer: Mike Devour <[email protected]> >
