Hi Tony, I got a bit more serious about measuring the thickness and discovered the 2 inner electrodes are actually about .008" and the outer ones are about .011" so the silver is leaving the electrodes. The problem with measuring is that they are so close to each other and they're also corrugated for rigidity that I cannot get the caliper in place. I cannot see or feel any porosity.
Trem ----- Original Message ----- From: "Tony Moody" <a...@new.co.za> To: <silver-list@eskimo.com> Sent: Sunday, June 15, 2003 7:21 AM Subject: Re: CS>$$$ perpectives > Trem, > Could it be that the process is mining into the the mass of silver, > corroding tunnels and cavities, while leaving the surface fairly intact? > This is classic in stainless steel where the bottom of the hole is > preferentially corroded, leading to disasterous cracks very quickly. This > usually happens close to welded areas and also in stressed areas. > Tony > > Trem wrote: > > Well this is really interesting. Since the electrodes have about 2.3 or > > a bit more ounces of usable silver and they are still there although > > reduced in thickness a bit and since I know the PPM is not .3 but 20 > > because of independent lab tests, there can be no explanation other than > > I was mistaken in the estimated quantity produced. > > > > See below for further comments. > > > > Trem > > > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > Instructions for unsubscribing may be found at: http://silverlist.org > > To post, address your message to: silver-list@eskimo.com > > Silver-list archive: http://escribe.com/health/thesilverlist/index.html > > List maintainer: Mike Devour <mdev...@eskimo.com> > > > >
