Hi Stuff,
Either spread the electrodes a little further apart or don't immerse them as
deep in the water. That will increase the PPM shutoff point.
I hope this helps you,
Best regards,
Trem Williams
[email protected]
www.silvergen.com
----- Original Message -----
From: "Stuff" <[email protected]>
To: <[email protected]>
Sent: Wednesday, December 14, 2005 9:48 AM
Subject: Re: CS>HOMEMADE VS. SOVEREIGN, LYME DISEASE
At 10:43 AM 12/14/2005, Marshall wrote:
The silvergen SG6 is a very good unit. It can produce EIS of over 20 ppm
consistantly.
It is a very good unit, but the most I can get out of it is around 16.5 uS
(unit set on high) measured with
the Hanna PWT and using starting water that measures .2 to .4 uS
stuff
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: [email protected]
Address Off-Topic messages to: [email protected]
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <[email protected]>
