Trem,
Thanks!
I'm not unhappy with 14 or 15 uS. And if the use of the 1.2
multiplication factor is still good to use, that means actual ppm is
around 18, which is fine with me.
But if you would email me how to adjust the trimpot that would be great.
Unless it is obvious which way one would turn it?
I think I'd like to try it just to have a bit of fun.
sol
Trem wrote:
Hi Sol,
The internal shutoff adjustment would take care of it. It's a simple
adjustment of a trimpot.
I hope this helps you,
Best regards,
Trem Williams
[email protected]
www.silvergen.com
----- Original Message ----- From: "sol" <[email protected]>
To: <[email protected]>
Sent: Wednesday, December 14, 2005 3:15 PM
Subject: Re: CS>HOMEMADE VS. SOVEREIGN, LYME DISEASE
Trem,
It does increase the shut off point a little, but certainly not up
to 20 uS. This is just my own experience. Indeed to get to 16.5 uS I
already have spread the electrodes about a half inch farther apart at
bottom than they are at their attachment points. I also reduced the
level of the water in the jar by 1/4 inch.
16.5 is it for me, unless I then clean electrodes and re-process,
which only gets me about another 1.0 uS .
All in all the messing about isn't worth it for the increase (my
opinion only). 14.9 uS is really not that far off 16.5 uS in terms of
effectiveness, so far as I can tell.
sol
Trem wrote:
Hi Stuff,
Either spread the electrodes a little further apart or don't immerse
them as deep in the water. That will increase the PPM shutoff point.
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: [email protected]
Address Off-Topic messages to: [email protected]
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <[email protected]>
--
Whenever you find you are on the side of the majority, it is time to pause and reflect. Mark Twain
