Not sure I never waited for 5 min if it did not associate in less then 30 seconds I figured it was busted :-) ----- Original Message ----- From: "The Wirefree Network" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, July 21, 2003 11:06 PM Subject: RE: Re[2]: [smartBridges] Firmware Issue
Now this actually hits a key point. I installed a new client 2 days ago. The client was about 2 blocks from my head-end unit. The client was not associating for some reason on their side. However, when I logged into the aPPo, it showed that the client was associated with super RSSI/LQ. It took about 5 minutes before the client actually fully associated. Seemed odd to me. Is this the timing problem we are all experiencing?? FACTS: My head-end aPPo is new from June. My client airBridge is new also bought in June. Sullyl -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Blazen Wireless Sent: Monday, July 21, 2003 3:19 PM To: [EMAIL PROTECTED] Subject: Re: Re[2]: [smartBridges] Firmware Issue I would think if it was degrading power or performance you would see that in the site survey screen at all the places I tested where ver 0.01.04 worked great RSSI showed at 85 and signal at 895 now when I loaded the new ver 0.01.06 I went to the site survey screen and looked in the list and it showed my APPO's and very good signal but just would not associate? if the performance was decreased I would assume I would see lower signal quality please correct me if I am wrong? I think now what they are dealing with is a timing issue the further out you go the worse it gets??? ----- Original Message ----- From: "The Wirefree Network" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, July 21, 2003 3:45 PM Subject: RE: Re[2]: [smartBridges] Firmware Issue I was actually wondering the same thing myself. What exactly is this firmware doing?? If it is degrading the radio performance to mask the actual root problem, then please let us know. It is one thing to have degraded airBridge at a client's home, it is another if my head-end aPPo is NOT operating at PEAK efficiency. Please assure us that this is NOT the case. Thanks!! Sully -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Barry at Mutual Data Sent: Monday, July 21, 2003 2:37 PM To: sB Tech Support Subject: Re[2]: [smartBridges] Firmware Issue Hello sB, This is not the response I want to see or hear about a product that is in my network. "MAGIC" is BS when the customer quits telling me they are always down. I don't believe for an instant that "firmware" is fixing an overheating issue. I was trained as an Electronics Tech and have 12 plus years of fixing electronics to the board level as experience. Adding some code is not going to change a flaky component. Basically is the firmware degrading the radio operation to the point the component does not overheat? Fortunately, I only have a few SB products left in the system plus the ones in the junk box. Barry Monday, July 21, 2003, 2:05:44 PM, you wrote: sTS> I know this is hard to believe. Sometimes when you try to associate to sTS> AP that has no WEP enabled, it tell you to check the authentication and sTS> WEP, try do a power cycle the unit or reboot the PC, it may work then. sTS> It is just a magic trick. sTS> Alex sTS> sB Tech Support --- [This E-mail scanned for viruses by Declude Virus] The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
