Here is a basic diagram of the setup: Aironet AP --> Total --> ethernet --> APPO.
At 08:08 AM 9/3/2003 -0400, you wrote:
Can anyone tell me if they have used an Airbridge Total to backhaul to an APPO in AP mode. I am trying to cut cost in the backhaul and just want to use the bridge to AP then have the clients connect via other bridges to the AP.
Question 2: I am up 200 ft with a 12 Dbi Omni and can only get about 2 miles NLOS and about 5 LOS. Anyone gotten further?
Question 3: Does anyone use splitters and AMPS the the AirBridge Outdoor and APPO? What kind?
Rudolph Worrell President Phone:(540)664-3950 Fax:(270)458-6431 www.wave2net.com
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Jason Sent: Wednesday, September 03, 2003 7:56 AM To: [EMAIL PROTECTED] Subject: RE: [smartBridges] Ethernet side going down
I'd say it is not new. I recently had two APPOs that started exhibiting this behavior after 6 months of perfect performance. It happened after I upgraded the firmware, and switched the operational modes, and everything went to pot. They exhibited the same behavior you are describing (except only when in access point mode - bridge or client modes were fine). Also, the ethernet "went away" for only about 10 minutes at a time, then would reappear.
I never got to the bottom of it - decided to stop wasting my time and worked around it with other gear.
Jason
> -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of D G > Sent: Wednesday, September 03, 2003 7:33 AM > To: [EMAIL PROTECTED] > Subject: [smartBridges] Ethernet side going down > > > > > Anyone notice a new issue with ethernet sides going down for > no reason? > > Our last 2 installs are doing this. One is an ABT that the > ethernet side will go away for anywhere between 20 minutes to > an hour then come back up. We were running a ping test over > the weekend and was what it has been doing. > > The other is an ABI in an outdoor enclosure. It needed a > power cycle yesterday morning to bring it back and it looks > like it's been down for about 6 hours now. Probably need to > do a power cycle to bring it back up in the morning. I'm > pinging the radio side right now so I know it is powered up > but I can't get to the box behind it. > > Both installs are under a week old. Both units were upgraded > to .7 The ABT has been around the office for a couple of > weeks and the ABI came in and went out last week. > > > Don Grossman > www.willitsonline.com > icq# 4224548 > > ----------ANNOUNCEMENT---------- > Don't forget to register for WISPCON IV > http://www.wispcon.info/us/wispcon-> iv/wispcon-iv.htm > > The > PART-15.ORG smartBridges Discussion > List > To Join: mailto:[EMAIL PROTECTED] (in the body type > subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm
The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm
The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges)
Archives: http://archives.part-15.org
----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm
The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges)
Archives: http://archives.part-15.org
