Dan, Is this an Airbridge Total? -- Rudolph Worrell President Phone:(540)664-3950 Fax:(270)458-6431 www.wave2net.com
Quoting Dan Petermann <[EMAIL PROTECTED]>: > I'm using 1 total as a back haul. It's AP is an old Aironet BR-500 used for > > the uplink. I've had it in this configuration for about 2 months and > haven't had a problem with it yet. It feeds the main AP with nothing more > than an ethernet cable in between them. From my house 4.5 miles away with > marginal LOS I consistently get around 1200k of thruput. The uplink AP is > fed by a single T-1. > > Here is a basic diagram of the setup: Aironet AP --> Total --> ethernet --> > > APPO. > > At 08:08 AM 9/3/2003 -0400, you wrote: > >Can anyone tell me if they have used an Airbridge Total to backhaul to an > >APPO in AP mode. I am trying to cut cost in the backhaul and just want to > >use the bridge to AP then have the clients connect via other bridges to > the > >AP. > > > >Question 2: I am up 200 ft with a 12 Dbi Omni and can only get about 2 > >miles NLOS and about 5 LOS. Anyone gotten further? > > > >Question 3: Does anyone use splitters and AMPS the the AirBridge Outdoor > >and APPO? What kind? > > > >Rudolph Worrell > >President > >Phone:(540)664-3950 > >Fax:(270)458-6431 > >www.wave2net.com > > > >-----Original Message----- > >From: [EMAIL PROTECTED] > >[mailto:[EMAIL PROTECTED] Behalf Of Jason > >Sent: Wednesday, September 03, 2003 7:56 AM > >To: [EMAIL PROTECTED] > >Subject: RE: [smartBridges] Ethernet side going down > > > > > >I'd say it is not new. I recently had two APPOs that started exhibiting > >this behavior after 6 months of perfect performance. It happened after I > >upgraded the firmware, and switched the operational modes, and > >everything went to pot. They exhibited the same behavior you are > >describing (except only when in access point mode - bridge or client > >modes were fine). Also, the ethernet "went away" for only about 10 > >minutes at a time, then would reappear. > > > >I never got to the bottom of it - decided to stop wasting my time and > >worked around it with other gear. > > > >Jason > > > > > -----Original Message----- > > > From: [EMAIL PROTECTED] > > > [mailto:[EMAIL PROTECTED] On Behalf Of D G > > > Sent: Wednesday, September 03, 2003 7:33 AM > > > To: [EMAIL PROTECTED] > > > Subject: [smartBridges] Ethernet side going down > > > > > > > > > > > > > > > Anyone notice a new issue with ethernet sides going down for > > > no reason? > > > > > > Our last 2 installs are doing this. One is an ABT that the > > > ethernet side will go away for anywhere between 20 minutes to > > > an hour then come back up. We were running a ping test over > > > the weekend and was what it has been doing. > > > > > > The other is an ABI in an outdoor enclosure. It needed a > > > power cycle yesterday morning to bring it back and it looks > > > like it's been down for about 6 hours now. Probably need to > > > do a power cycle to bring it back up in the morning. I'm > > > pinging the radio side right now so I know it is powered up > > > but I can't get to the box behind it. > > > > > > Both installs are under a week old. Both units were upgraded > > > to .7 The ABT has been around the office for a couple of > > > weeks and the ABI came in and went out last week. > > > > > > > > > Don Grossman > > > www.willitsonline.com > > > icq# 4224548 > > > > > > ----------ANNOUNCEMENT---------- > > > Don't forget to register for WISPCON IV > > > http://www.wispcon.info/us/wispcon-> iv/wispcon-iv.htm > > > > > > The > > > PART-15.ORG smartBridges Discussion > > > List > > > To Join: mailto:[EMAIL PROTECTED] (in the body type > > > subscribe smartBridges <yournickname> To Remove: > >mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) > >Archives: http://archives.part-15.org > > > >----------ANNOUNCEMENT---------- > >Don't forget to register for WISPCON IV > >http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm > > > >The PART-15.ORG smartBridges Discussion List > >To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > >smartBridges <yournickname> > >To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > >smartBridges) > >Archives: http://archives.part-15.org > > > >----------ANNOUNCEMENT---------- > >Don't forget to register for WISPCON IV > >http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm > > > >The PART-15.ORG smartBridges Discussion List > >To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > >smartBridges <yournickname> > >To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > >smartBridges) > >Archives: http://archives.part-15.org > > > ----------ANNOUNCEMENT---------- > Don't forget to register for WISPCON IV > http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges > <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > smartBridges) > Archives: http://archives.part-15.org > ------------------------------------------------- This mail sent through IMP: http://horde.org/imp/ ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
