RE: [smartBridges] bridging through a switch with AB

[Rudolph Worrell]



Hey Sevak,

 

I just used a straight cable into the switch.  I finally saw the AP indoor and it kept going in and out.  Well now my head end AP is out and the whole network was feeding off it so guess what?  Some really unhappy customers.

 

To make matters worst, the AP is on a water tower belonging to the city who do not work on the weekends so I am down until Monday.   arrrrgghh!

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of Sevak Avakians
Sent: Saturday, October 04, 2003 10:33 AM
To: [EMAIL PROTECTED]
Subject: Re: [smartBridges] bridging through a switch with AB

Rudy,

Is your cross-over cable into the uplink port of your switch?  If so, did you need to press a button to make that an uplink port?  You really don't need to use cross-over into the switch.  Just stick a straight CAT5 into any regular port of the switch and you'll be ok.

Sevak

On Fri, 2003-10-03 at 21:28, Rudolph Worrell wrote:

Ok

So the proper way to repeat is to go from AP to AP/AB to switch/cross over
cable to AP right?

Well,  I did this and I cannot see the other AP on the other side of the
switch.  Where did I go wrong?

Rudy


----------ANNOUNCEMENT----------
Don't forget to register for WISPCON IV
http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm

The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges)
Archives: http://archives.part-15.org