Spanning tree? -----Original Message----- From: Rick Kosick [mailto:[EMAIL PROTECTED] Sent: Friday, November 07, 2003 11:46 AM To: [EMAIL PROTECTED] Subject: [smartBridges] Riddle me this...
I'm running another brand bridge as a primary backhaul (Airaya). I installed the SB's as a backup but the thing is, I need to let one of the twp SB units remained powered on (the one at the tower). This way, if the main backhaul dies, I can power on the SB on the ground and reach the lit unit. Problem is... with two bridges running, its causing Ethernet interference. More than likely the airPoint is announcing a route back to the powered-down airBridge and creating two paths back to the NOC. If I unplug the airPoint from the ethernet, all is good again. Any way to have the airPoint stop this? Or maybe the move is to swap the units so that the airPoint is at the NOC on the ground and the airBridge is on the tower? === Rick Kosick StarLinX Internet Service The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
