If I had a 100 mw radio I wouldn't have to buy a 10 db amp....
On Tue, 11 Nov 2003, Pascal Losier wrote: > Using low power is a good choice for a radio. > It let you install an amp which also increse Rx gain. > Most antenna increase Rx & Tx. > Having a 23 dbm radio would not let you install a 10db amp & 12b sector. > > > So It's OK. > > + I just did a 13 miles link with a 24Db grid at the AB..... APPO have a > 12db omni. > > 17.5 dbm can do pretty far, > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Sam > Sent: Tuesday, November 11, 2003 10:24 PM > To: [EMAIL PROTECTED] > Subject: RE: [smartBridges] Low power output > > > Alex > > Why not make the radios put out 100 mw? > > Sam > > > On Wed, 12 Nov 2003, sB Tech Support wrote: > > > At 17.5 dbm output power and with appropriate antenna, you can achieve > > > long range and stay within FCC regulation. Using AMP is not > > recommended by us as it introduces noise, unless there is special need > > > for it. > > > > > > > > Alex > > > > sB Tech Support > > > > [EMAIL PROTECTED] > > > > > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED] On Behalf Of Kevin Sullivan > > Sent: Wednesday, November 12, 2003 5:04 AM > > To: [EMAIL PROTECTED] > > Subject: [smartBridges] Low power output > > > > > > > > Smartbridges people, > > > > Why does the Smartbridges AP have such a low power output? At 56.2 > > > milliwatts it has a lower trasmit power than most off-the-shelf AP's. > > Is there any way up the power levels? > > > > Kevin > > > > > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in > the body type unsubscribe smartBridges) > Archives: http://archives.part-15.org > > > > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges > <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) > Archives: http://archives.part-15.org > The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
