At 07:51 PM 10/3/2007, Soren Kristensen wrote: >Hi Everybody, > >I just posted a net5501 BIOS update with: >comBIOS vers 1.32h > > * fixed IDE DMA enable issue on net5501 > * fixed soft reboot issue on net5501
Hi, Unfortunately, I still see the soft reboot issue on FreeBSD. e.g. from the bootloader prompt, if I try to reboot, the box will hang and never reboot Nothing fancy about my bios settings, other than the speed is set to 9600 POST: 012345689bcefghips1234ajklnopqr,,,tvwxy comBIOS ver. 1.32h 20071004 Copyright (C) 2000-2007 Soekris Engineering. net5501 0512 Mbyte Memory CPU Geode LX 500 Mhz Pri Sla LEXAR ATA FLASH LBA 994-16-63 501 Mbyte Slot Vend Dev ClassRev Cmd Stat CL LT HT Base1 Base2 Int ------------------------------------------------------------------- 0:01:2 1022 2082 10100000 0006 0220 08 00 00 A0000000 00000000 10 0:06:0 1106 3053 02000096 0117 0210 08 40 00 0000E101 A0004000 11 0:07:0 1106 3053 02000096 0117 0210 08 40 00 0000E201 A0004100 05 0:08:0 1106 3053 02000096 0117 0210 08 40 00 0000E301 A0004200 09 0:09:0 1106 3053 02000096 0117 0210 08 40 00 0000E401 A0004300 12 0:20:0 1022 2090 06010003 0009 02A0 08 40 80 00006001 00006101 0:20:2 1022 209A 01018001 0005 02A0 08 00 00 00000000 00000000 0:21:0 1022 2094 0C031002 0006 0230 08 00 80 A0005000 00000000 15 0:21:1 1022 2095 0C032002 0006 0230 08 00 00 A0006000 00000000 15 1 Seconds to automatic boot. Press Ctrl-P for entering Monitor. 1 FreeBSD 2 FreeBSD Default: 1 /boot.config: -hConsoles: serial port BIOS drive C: is disk0 BIOS 639kB/523264kB available memory FreeBSD/i386 bootstrap loader, Revision 1.1 ([EMAIL PROTECTED], Sat Sep 15 01:52:01 EDT 2007) Loading /boot/defaults/loader.conf /boot/kernel/kernel text=0x258e14 data=0x2bed4+0x16018 syms=[0x4+0x359d0+0x4+0x45239] - Hit [Enter] to boot immediately, or any other key for command prompt. Type '?' for a list of commands, 'help' for more detailed help. OK reboot Rebooting... at this point its totally hung and needs a power cycle dmesg looks like the following Copyright (c) 1992-2007 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD is a registered trademark of The FreeBSD Foundation. FreeBSD 6.2-STABLE #1: Tue Sep 18 11:35:06 EDT 2007 [EMAIL PROTECTED]:/usr/obj/nanobsd-soekris5501/usr/src/sys/nano5501 Timecounter "i8254" frequency 1193182 Hz quality 0 CPU: Geode(TM) Integrated Processor by AMD PCS (499.90-MHz 586-class CPU) Origin = "AuthenticAMD" Id = 0x5a2 Stepping = 2 Features=0x88a93d<FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CLFLUSH,MMX> AMD Features=0xc0400000<MMX+,3DNow+,3DNow> real memory = 536870912 (512 MB) avail memory = 520265728 (496 MB) K6-family MTRR support enabled (2 registers) cpu0 on motherboard pcib0: <Host to PCI bridge> pcibus 0 on motherboard pci0: <PCI bus> on pcib0 Geode LX: Soekris net5501 comBIOS ver. 1.32h 20071004 Copyright (C) 2000-2007 MFGPT bar: f00100006200 pci0: <encrypt/decrypt, entertainment crypto> at device 1.2 (no driver attached) vr0: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe100-0xe1ff mem 0xa0004000-0xa00040ff irq 11 at device 6.0 on pci0 miibus0: <MII bus> on vr0 ukphy0: <Generic IEEE 802.3u media interface> on miibus0 ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto vr0: Ethernet address: 00:00:24:c8:e2:24 vr1: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe200-0xe2ff mem 0xa0004100-0xa00041ff irq 5 at device 7.0 on pci0 miibus1: <MII bus> on vr1 ukphy1: <Generic IEEE 802.3u media interface> on miibus1 ukphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto vr1: Ethernet address: 00:00:24:c8:e2:25 vr2: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe300-0xe3ff mem 0xa0004200-0xa00042ff irq 9 at device 8.0 on pci0 miibus2: <MII bus> on vr2 ukphy2: <Generic IEEE 802.3u media interface> on miibus2 ukphy2: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto vr2: Ethernet address: 00:00:24:c8:e2:26 vr3: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe400-0xe4ff mem 0xa0004300-0xa00043ff irq 12 at device 9.0 on pci0 miibus3: <MII bus> on vr3 ukphy3: <Generic IEEE 802.3u media interface> on miibus3 ukphy3: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto vr3: Ethernet address: 00:00:24:c8:e2:27 isab0: <PCI-ISA bridge> at device 20.0 on pci0 isa0: <ISA bus> on isab0 atapci0: <GENERIC ATA controller> port 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xe000-0xe00f at device 20.2 on pci0 ata0: <ATA channel 0> on atapci0 ata1: <ATA channel 1> on atapci0 ohci0: <OHCI (generic) USB controller> mem 0xa0005000-0xa0005fff irq 15 at device 21.0 on pci0 ohci0: [GIANT-LOCKED] usb0: OHCI version 1.0, legacy support usb0: <OHCI (generic) USB controller> on ohci0 usb0: USB revision 1.0 uhub0: AMD OHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 4 ports with 4 removable, self powered pci0: <serial bus, USB> at device 21.1 (no driver attached) orm0: <ISA Option ROM> at iomem 0xc8000-0xd27ff on isa0 sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 16550A, console sio1 at port 0x2f8-0x2ff irq 3 on isa0 sio1: type 16550A Timecounter "TSC" frequency 499904611 Hz quality 800 Timecounters tick every 1.000 msec ad1: 489MB <LEXAR ATA FLASH V1.02> at ata0-slave PIO4 Trying to mount root from ufs:/dev/ad1s1a ---Mike > * change initial clear screen to scroll lines > >There might still be issues with Ultra-DMA detect/setting, I would be >happy to get a few success/failure reports, just email me directly. > >Also, I'm still investigating how 40/80 wire cable reporting should be >done.... > > >Best Regards, > > >Soren Kristensen > >CEO & Chief Engineer >Soekris Engineering, Inc. > >_______________________________________________ >Soekris-tech mailing list >Soekris-tech@lists.soekris.com >http://lists.soekris.com/mailman/listinfo/soekris-tech _______________________________________________ Soekris-tech mailing list Soekris-tech@lists.soekris.com http://lists.soekris.com/mailman/listinfo/soekris-tech