Hi all,

I've been trying to install AstLinux on my brand new net5501 and haven't
had much luck with the USB port. The port is recognized correctly on
boot, but seems unpowered - any devices I connect to it (USB flash
drives, hubs (powered and unpowered), printers) are not recognized.

Since net5501 support is only in the dev. version of AstLinux, I've also
tried Voyage Linux and OpenBSD with similar results. In each case the OS
seems to detect the port, but the port itself appears unpowered. No new
USB entries appear in dmesg output when I plug in a device.

Is there any trick to getting this to work, or could I have a bad board?
 Everything else on the board appears to work properly.

Regards,
- Mike


Relevant usb bits from dmesg output in Voyage Linux (0.5):

> usbcore: registered new interface driver usbfs                                
>   
> usbcore: registered new interface driver hub                                  
>   
> usbcore: registered new device driver usb                                     
>   
> PCI: Setting latency timer of device 0000:00:15.1 to 64                       
>   
> ehci_hcd 0000:00:15.1: EHCI Host Controller                                   
>   
> ehci_hcd 0000:00:15.1: new USB bus registered, assigned bus number 1          
>   
> ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller (OHCI) Driver         
>   
> ehci_hcd 0000:00:15.1: irq 15, io mem 0xa0006000                              
>   
> ehci_hcd 0000:00:15.1: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004         
>   
> usb usb1: configuration #1 chosen from 1 choice                               
>   
> hub 1-0:1.0: USB hub found                                                    
>   
> hub 1-0:1.0: 4 ports detected                                                 
>   
> PCI: Setting latency timer of device 0000:00:15.0 to 64                       
>   
> ohci_hcd 0000:00:15.0: OHCI Host Controller                                   
>   
> ohci_hcd 0000:00:15.0: new USB bus registered, assigned bus number 2          
>   
> ohci_hcd 0000:00:15.0: irq 15, io mem 0xa0005000                              
>   
> usb usb2: configuration #1 chosen from 1 choice                               
>   
> hub 2-0:1.0: USB hub found                                                    
>   
> hub 2-0:1.0: 4 ports detected

voyage:~# lsmod

Module                  Size  Used by

ipv6                  208132  14

dm_mod                 40640  0

i2c_core               18192  0

pc87360                16660  0

hwmon_vid               2432  1 pc87360

hostap_pci             44688  0

hostap                 94596  1 hostap_pci

ieee80211_crypt         4480  1 hostap

natsemi                22624  0

cs5535_gpio             3828  0

ohci_hcd               15620  0

ehci_hcd               23820  0

usbcore               100760  3 ohci_hcd,ehci_hcd

via_rhine              18312  0

mii                     4352  1 via_rhine

bitrev                  1792  2 natsemi,via_rhine

crc32                   3840  2 natsemi,via_rhine

_______________________________________________
Soekris-tech mailing list
[email protected]
http://lists.soekris.com/mailman/listinfo/soekris-tech

Reply via email to