Hi, Are your UPS sending traps in v2c or v3? I'm not sure what Spectrum versions are affected by this bug, but it's not processing v2c or v3 traps. Check with a traffic analyzer witch trap version are using your UPS. Some devices send v2c traps even though they're configured to use v1.
With the traffic analyzer (wireshark or tcpdump) running in SS, you can also make sure your SS server is receiving the traps. Sometimes you thinks it's a Spectrum problem but really your server is not even receiving the trap!!! Regards. James. On Thu, Mar 31, 2011 at 5:20 PM, Mickey Alderson <[email protected]> wrote: > Disclaimer - running version 9.1.1.7.13 on Windows 2003. > > We've got a couple hundred APC SmartUPS units installed on the network, with > SNMP management cards installed and configured to send traps to Spectrum, > but we're not showing any alarms for when utility power is lost, or > temperature/humidity threshold violations. I've got a UPS here at my desk > as a test, modeled it, made sure the trapreceiver settings were configured > correctly, and then pulled the plug to make it run on battery power, but I'm > not showing any events in the Spectrum device events tab. I know this was > working in version 8.1, but for some reason it's not working in 9.1. I've > even loaded the latest Powernet MIB and gone through the Event Configuration > table to make sure there are alarm severities configured on all the relevant > events, and still nothing. Anybody having similar problems, and what did > you do to correct the issue(s), if anything? Thanks! > > -- > Mickey Alderson > mobile. 901.833.4908 > email. [email protected] > > --To unsubscribe from spectrum, send email to [email protected] with the > body: unsubscribe spectrum [email protected] --- To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected]
