Hello all,
Well, after searching around for a paint shop that will spray the Spit for the amount of money i want and being shot down time after time, I have decided to do more of the body prep work myself than i had originally wanted to do. That being said, i was wondering if i could get some lister knowledge on different body prep techniques. - Body filler: I only have a couple places that need bondo to smooth them out (rear end of the rocker panels where the guys welded them in). I also found out that the DPO decided to fill in the whole front end of the hood where the letters T-R-I-U-M-P-H are because it had been smashed in, Should i attempt to undo that? or is undoing body filller a no no? Any name brands that I should stick to or stay away from? - Sanding: 180-grit ok for the whole car before priming? Or should i go finer than that? I am not planning on taking the whole car down to bare metal - Priming: Spray it myself? Or leave that to the painter? Again...Brand names to use or not use? I figure i will at least try my hand at it in some un-noticable spots (trunk, underside of bonnet). Than sanding the primer? how fine should i go for before paint?

Thanks,
 Dave

Your messages not reaching the list?
Check out http://www.team.net/posting.html

===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org

===  unsubscribe/change address requests to [EMAIL PROTECTED]  or try
===  http://www.team.net/cgi-bin/majorcool
===  Other lists available at
===      http://www.team.net/mailman/listinfo
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local
===  Edit your replies!

Reply via email to