Dave, I am just completing repainting my whole spit. I did all the work myself. This is the third car that I have painted. Your answers depend on what you want when done. I would be surprised if you don't wind up bondoing more than two spots. You should at least sand down to the first or original layer of paint. If the bottom layer of paint isn't original then I suggest sanding down as far as possible. You didn't say if you would be removing all parts and painting each piece separately, that is what I do. To get started easily you should first tackle one of the two previously bondoed areas. I suggest using a 80 or 40 grit with a bondo hog or DA sander and taking out the bondo on the nose. Go to bare metal as much as you can and take the paint off at least 5 inches further than their bondo went. Bondo in the gallon is cheap, buy a gallon. I suggest going to your local auto paint store, they will tell you what brand to go with. Make sure it is a two part or catalyzed bondo. Go to yo! ur bookstore and read up on body and paint - don't put the bondo on too deep, hammer out the metal if it is too deep. Also buy a 1/3 sheet sanding block, 1/2 sheet soft sanding block, 180 grit dry paper, extra long sanding block and some stick on 120 grit paper, cheap black spray paint for blocking/guide coat. Put on the bondo, DA sand it to shape, put on more bondo, spray a guide coat, go at it with your extra long block and 120 grit, or 80/40 grit with an air flat sander or your extra long board. When you think you might have it close then mask off the area and shoot a primer surfacer on the nose, guide coat, then go at it with the 180 grit. Likely repeat the steps. That will get you about 20 working hours into the job. Once you get that far you will have an idea of the rest of the job. Rob
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of David Mayer Sent: Tuesday, November 01, 2005 2:37 PM To: [email protected] Subject: Body work suggestions? Hello all, Well, after searching around for a paint shop that will spray the Spit for the amount of money i want and being shot down time after time, I have decided to do more of the body prep work myself than i had originally wanted to do. That being said, i was wondering if i could get some lister knowledge on different body prep techniques. - Body filler: I only have a couple places that need bondo to smooth them out (rear end of the rocker panels where the guys welded them in). I also found out that the DPO decided to fill in the whole front end of the hood where the letters T-R-I-U-M-P-H are because it had been smashed in, Should i attempt to undo that? or is undoing body filller a no no? Any name brands that I should stick to or stay away from? - Sanding: 180-grit ok for the whole car before priming? Or should i go finer than that? I am not planning on taking the whole car down to bare metal - Priming: Spray it myself? Or leave that to the painter? Again...Brand names to use or not use? I figure i will at least try my hand at it in some un-noticable spots (trunk, underside of bonnet). Than sanding the primer? how fine should i go for before paint? Your messages not reaching the list? Check out http://www.team.net/posting.html === This list supported in part by The Vintage Triumph Register === http://www.vtr.org === unsubscribe/change address requests to [EMAIL PROTECTED] or try === http://www.team.net/cgi-bin/majorcool === Other lists available at === http://www.team.net/mailman/listinfo === Archives at http://www.team.net/archive === http://www.team.net/the-local === Edit your replies!
