No just 3 presses that the scrap falls down to the conveyor and then gets carried through the tunnels to the dumpster room. This is stamping so I believe the scrap will be more solid than shavings or dust. I just heard rumor they may spray these with a water/oil mixture? There will be a couple of sumps in the bottom to pump out extra. I'm verifying this with the contractor. I believe that would probably go to EH I at that point.
Bobby Gillett Sr. Project Manager Key Fire Protection, Inc. (731) 424-0130 office (731) 424-9285 fax (731) 267-4853 cell [email protected] -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Todd Williams Sent: Tuesday, November 17, 2009 12:40 PM To: [email protected] Subject: RE: Tunnels Any grinding or trimming? Aluminum? At 01:35 PM 11/17/2009, you wrote: >Not exactly sure but they are stamping metal car parts through three >different presses. Being its an open conveyor I believe they are not real >fine. > >Bobby Gillett >Sr. Project Manager >Key Fire Protection, Inc. >(731) 424-0130 office (731) 424-9285 fax >(731) 267-4853 cell >[email protected] > > > >-----Original Message----- >From: [email protected] >[mailto:[email protected]] On Behalf Of å... .... >Sent: Tuesday, November 17, 2009 12:31 PM >To: [email protected] >Subject: Re: Tunnels > >How fine are the fines? Even reduced iron burns if you get it fine enough. >Probably not a problem for your situation, but thought the question should >be >asked. > >scot deal >excelsior fire >_______________________________________________ >Sprinklerforum mailing list >[email protected] >http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum > >For Technical Assistance, send an email to: [email protected] > >To Unsubscribe, send an email to:[email protected] >(Put the word unsubscribe in the subject field) > >_______________________________________________ >Sprinklerforum mailing list >[email protected] >http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum > >For Technical Assistance, send an email to: [email protected] > >To Unsubscribe, send an email to:[email protected] >(Put the word unsubscribe in the subject field) Todd G. Williams, PE Fire Protection Design/Consulting Stonington, Connecticut www.fpdc.com 860.535.2080 _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field)
