Except for the pre 1910 crowd, Corvettes and Trabants (& race cars)
these are not made of wood or fiberglass. I don't think they're like
boat storage at all apart from looking similar (kind of like a zebra
isn't a horse and it's way deeper than the stripes). And yes they are
full of plastic, and yes when they catch fire they are hard to put out
but if they catch fire they're pretty much toast (pun pardon here) but
what if we contain it to the design area rather than worry about every
square inch of flat surface? Why not save most of the stuff (isn't
that what we do?) at the cost of the newly detailed Beemer (Western
pronunciation)?

On Mon, Mar 1, 2010 at 5:23 AM, George Church <[email protected]> wrote:
> Out my daughter's window with a view of the Lincoln Tunnel, there was a
> Mercedes dealer in the foreground with these lifts wall to wall in most
> parking areas. I'd assume they were used for new cars and the service
> klunkers stayed on the bottom level?
>
> Tom, woud this present a dramatically different obstruction scenario than a
> topped, open air bus?
>
> glc
>
> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]] On Behalf Of Bill Brooks
> Sent: Monday, March 01, 2010 8:05 AM
> To: [email protected]
> Subject: RE: sidewall obstruction digression
>
> There must be some solid surface between the two levels to create an
> intermediate ceiling?  Otherwise somebody's '87 Chevy Caprice Brougham is
> dripping who knows what on the finish of my newly detailed Bimmer
> convertible.  What about winter or rain when melting snow drops on the car
> below?
>
> Bill Brooks
>
> William N. Brooks, P.E.
> Brooks Fire Protection Engineering Inc.
> 372 Wilett Drive
> Severna Park, MD 21146-1904
> 410-544-3620
> 410-544-3032 FAX
> 412-400-6528 Cell
>
>
> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]] On Behalf Of Tom Duross
> Sent: Sunday, February 28, 2010 1:37 PM
> To: [email protected]
> Subject: sidewall obstruction digression
>
> I have a possible sidewall obstruction issue coming up on a new project.
> The building owner dug out his basement level from poured concrete on dirt
> to a full 11' high for a garage.  Pinned and poured footings, columns,
> walls, etc., had a structural engineer help him.  Amazing job, not done yet.
> So in addition to a wavy rough old concrete ceiling he also tells me that he
> wants to put in vehicle lifts to double up the parking capacity (110' x 110'
> inside).
> I'm planning on a wet system for the garage but wondering about protection
> below the lifts when there's a vehicle on top.  It's OH so technically I
> can't use sidewalls but the sketch of the cantilevered lift shows it 9'
> long.  I guess no SUV's or trucks will go on top, he says 11' will work.
> How have you guys done this?  I was thinking a sidewall against the back
> wall with a baffle at 5' above the floor off the overhead wet system might
> do it.  Wondering about calcing the low heads with the overhead too.
>
> Tom
>
>
> _______________________________________________
> Sprinklerforum mailing list
> [email protected]
> http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum
>
> For Technical Assistance, send an email to: [email protected]
>
> To Unsubscribe, send an email to:[email protected]
> (Put the word unsubscribe in the subject field)
>
> _______________________________________________
> Sprinklerforum mailing list
> [email protected]
> http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum
>
> For Technical Assistance, send an email to: [email protected]
>
> To Unsubscribe, send an email to:[email protected]
> (Put the word unsubscribe in the subject field)
>
> _______________________________________________
> Sprinklerforum mailing list
> [email protected]
> http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum
>
> For Technical Assistance, send an email to: [email protected]
>
> To Unsubscribe, send an email to:[email protected]
> (Put the word unsubscribe in the subject field)
>



-- 
Ron Greenman
Instructor
Fire Protection Engineering
Bates Technical College
Tacoma, WA

Member:
SFPE, ASCET, NFPA, AFSA, NFSA AFAA, NIBS, WSAFM, WFC
_______________________________________________
Sprinklerforum mailing list
[email protected]
http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum

For Technical Assistance, send an email to: [email protected]

To Unsubscribe, send an email to:[email protected]
(Put the word unsubscribe in the subject field)

Reply via email to