Test checklist, and plan review checklist, as doc's, NFPA site.
NFPA 20, 2010 edition.
Bv
http://www.nfpa.org/aboutthecodes/AboutTheCodes.asp?DocNum=20&EditionID=644
-----Original message-----
From: rfletc...@aerofire.com
To: sprinklerforum@firesprinkler.org
Sent: Fri, Dec 21, 2012 14:13:27 GMT+00:00
Subject: RE: NFPA 20 Shop Drawings
There is a "Contractor's Material and Test Certificate for Fire Pump
Systems" in the 2010 Edition of the Pump Handbook.
Ron Fletcher
Aero - Phoenix
-----Original Message-----
From: sprinklerforum-boun...@firesprinkler.org
[mailto:sprinklerforum-boun...@firesprinkler.org] On Behalf Of Bill Brooks
Sent: Thursday, December 20, 2012 3:15 PM
To: sprinklerforum@firesprinkler.org
Subject: RE: NFPA 20 Shop Drawings
My interest is general at this point. However, I am preparing a
specification for a job which will require the preparation of fire pump
installation documentation. I thought I'd go right to NFPA 20 to find what's
needed, but it's not there as has been pointed out.
Seems each NFPA Standard should have a chapter which describes the minimum
amount of information needed to adequately document compliance.
Bill Brooks
-----Original Message-----
From: sprinklerforum-boun...@firesprinkler.org
[mailto:sprinklerforum-boun...@firesprinkler.org] On Behalf Of Bruce Verhei
Sent: Thursday, December 20, 2012 4:52 PM
To: sprinklerforum@firesprinkler.org
Subject: RE: NFPA 20 Shop Drawings
What does the ahj have on their website?
bv
-----Original message-----
From: Steve Leyton <st...@protectiondesign.com>
To: sprinklerforum@firesprinkler.org
Sent: Thu, Dec 20, 2012 21:31:14 GMT+00:00
Subject: RE: NFPA 20 Shop Drawings
You're right about there not being an explicit prescriptive for pump system
plans. But if I were an AHJ, I'd throw the applicable subsections of NFPA
13, Chapter 23 at the issue, such as 23.1.3(11),
23.2.1. As for detailing the pump room, that falls squarely into of
23.1.3 and the provisions for hydraulic calc's and substantiating
calc's.
Steve Leyton
-----Original Message-----
From: sprinklerforum-boun...@firesprinkler.org
[mailto:sprinklerforum-boun...@firesprinkler.org] On Behalf Of Bill Brooks
Sent: Thursday, December 20, 2012 1:24 PM
To: sprinklerforum@firesprinkler.org
Subject: NFPA 20 Shop Drawings
Seems as though there are no documentation requirements in NFPA 20 (like
NFPA 13, Chapter 22) when it comes to submittals and acceptance test
results. Am I missing the obvious?
Bill Brooks
William N. Brooks, P.E.
Brooks Fire Protection Engineering Inc.
372 Wilett Drive
Severna Park, MD 21146-1904
_______________________________________________
Sprinklerforum mailing list
Sprinklerforum@firesprinkler.org
http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum
_______________________________________________
Sprinklerforum mailing list
Sprinklerforum@firesprinkler.org
http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://fireball.firesprinkler.org/mailman/private/sprinklerforum/attachment
s/20121220/61b91204/attachment.html>
_______________________________________________
Sprinklerforum mailing list
Sprinklerforum@firesprinkler.org
http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum
_______________________________________________
Sprinklerforum mailing list
Sprinklerforum@firesprinkler.org
http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum
_______________________________________________
Sprinklerforum mailing list
Sprinklerforum@firesprinkler.org
http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://fireball.firesprinkler.org/mailman/private/sprinklerforum/attachments/20121221/f6f727f0/attachment.html>
_______________________________________________
Sprinklerforum mailing list
Sprinklerforum@firesprinkler.org
http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum
