Lazlo, it is not clear whether you are an engineer or an installing contractor. If you were either in the US I would recommend that you contact your insurance carrier to see if this type of project is within the scope of your insurance policy. In this country the owner would design the system or with the aid of a registered fire protection engineering firm.
Ed Vining 4819 John Muir Rd Martinez CA 94553 925-228-8792 Cell 925-787-0465 On Thu, Jul 18, 2013 at 7:15 AM, Ron Greenman <[email protected]> wrote: > May I ask what country? > > > On Thu, Jul 18, 2013 at 7:06 AM, Hinson, Ryan <[email protected]> > wrote: > > > As Craig said, this is a significant undertaking with multiple factors > > that need to be considered in the design. > > > > Has a hazard analysis been performed for the facility or portion thereof > > which is within your scope of work? The American Petroleum Institute > (API) > > has recommended practices (RP) for fire protection in refineries. It > must > > be noted that most API's are recommendations as opposed to directives. > > These directives are based upon a hazard analysis of the facility which > > includes input from various stakeholders - owner, owner's insurance > > underwriter (if any), refinery safety officials, emergency response > > representatives, AHJ's, and the like. Only after this has been performed > > should a system such as this be designed. Typically, a US-based refinery > > itself will have Company-specific requirements for fire protection > related > > systems. I suggest finding out if your client has anything like this. > API > > RP 2001 provides guidance for Fire Protection in Refineries and API RP > 2030 > > provides guidance for Fixed Water Spray in Refineries. If there is any > LPG > > processing going on, API Std 2510 and API Publ 2510A provide some > guidance > > and recommendations. All these API documents refer frequently to NFPA > > Codes and standards. Some of the more commonly referenced standards are > > 10, 11, 13, 15, 17, 20, 24, 30, 58, 70, and 72. This list is by no means > > complete. > > > > There are several questions that need to be answered which could have a > > significant impact on breadth of design(not to mention cost). Here is a > > partial list: > > - What, if any, is the fireproofing scheme to be used at the > > facility? > > - Refinery process and equipment configuration: > > - Has the equipment layout been finalized? > > - Storage tank/vessel location configurations relative to > > each other? > > - Storage tank/vessel location configurations relative to > > other equipment/process trains? > > - What are the characteristics of the existing water supply, if > any? > > - Is FM, CE or any other approval required for system components? > > (Most clients in the US require equipment listed for its intended use by > > an independent testing laboratory) > > - What is the maximum anticipated firewater demand for a single > fire > > incident including hose allowances? > > - Is some other type of suppressant besides water needed or > > anticipated? > > - Are water spray, top spray, vapor mitigation, or water mist type > > systems anticipated? > > - Anticipated protection of transformers, cooling towers, > > - Runoff containment and environmental requirements? > > - What are the monitoring requirements? > > - Are there aboveground suppression systems anticipated to be fed > > off the firewater loop? > > - If so, where? > > - What type of systems are they - automatic or manual? > > - How are they monitored? > > - Are there terminals in your scope? If so, there is a litany of > > other standards which may come into play. > > - What are the environmental characteristics of the facility's > > locality: > > - Ambient temperature range? > > - Seismic activity? > > - Proximity to populated areas? > > - Prevailing winds? > > - What is the training level of the personnel who will respond in a > > fire event? > > > > Hope this helps, > > > > Ryan Hinson > > Burns & McDonnell > > Direct: 952-656-3662 > > > > > > -----Original Message----- > > From: [email protected] [mailto: > > [email protected]] On Behalf Of László > Csonka > > Sent: Thursday, July 18, 2013 8:02 AM > > To: [email protected] > > Cc: [email protected] > > Subject: Re: - > > > > Yes! I'm talking about designing the underground fire loop to service > > hydrants, monitorsor etc. > > > > The problem is that the customer don't trust the country's regulations, > > those are not as safe as the US. regulations, so the fire protection > shall > > be according to the NFPA and API. > > > > L. > > > > > > > > > > 2013/7/18 <[email protected]> > > > > > Are you talking about designing an underground fire loop to service > > > hydrants or to serve sprinkler systems as well? > > > > > > For such a site as that you have a big job on your hands and much of > > > the design will not be out of NFPA Standards as the petroleum industry > > > has considerable documentation regarding fire protection. > > > > > > You also need to find out what are the Codes and Standards for the > > > country where it will be built as there are also regulations and Codes > > > that vary around the world. > > > > > > This question is not one that can be easily answered on a forum like > > this. > > > > > > Craig L. Prahl, CET > > > Fire Protection > > > CH2MHILL > > > Lockwood Greene > > > 1500 International Drive > > > Spartanburg, SC 29304-0491 > > > Direct - 864.599.4102 > > > Fax - 864.599.8439 > > > CH2MHILL Extension 74102 > > > [email protected] > > > > > > > > > -----Original Message----- > > > From: [email protected] [mailto: > > > [email protected]] On Behalf Of László > > > Csonka > > > Sent: Thursday, July 18, 2013 8:42 AM > > > To: [email protected] > > > Subject: - > > > > > > Hey Guys! > > > > > > I have to design a fire water network in an oil refinery. Somebody > > > could tell me which is the relating NFPA standard? > > > > > > Thanks! > > > > > > > > > > > > *László **Csonka* > > > * > > > * > > > fire safety expert > > > +36 20 983 4033 > > > [email protected] > > > _______________________________________________ > > > Sprinklerforum mailing list > > > [email protected] > > > > > > http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkl > > > er.org _______________________________________________ > > > Sprinklerforum mailing list > > > [email protected] > > > > > > http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkl > > > er.org > > > > > _______________________________________________ > > Sprinklerforum mailing list > > [email protected] > > > > > http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org > > _______________________________________________ > > Sprinklerforum mailing list > > [email protected] > > > > > http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org > > > > > > -- > Ron Greenman > Instructor > Fire Protection Engineering Technology > Bates Technical College > 1101 So. Yakima Ave. > Tacoma, WA 98405 > > [email protected] > > http://www.bates.ctc.edu/fireprotection/ > > 253.680.7346 > 253.576.9700 (cell) > > Member: > ASEE, SFPE, ASCET, NFPA, AFSA, NFSA, AFAA, NIBS, WSAFM, WFC, WFSC > > They are happy men whose natures sort with their vocations. -Francis Bacon, > essayist, philosopher, and statesman (1561-1626) > _______________________________________________ > Sprinklerforum mailing list > [email protected] > > http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org > _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org
