One of the talks I will be doing at the next NASS conference will be on a form of this dial that I developed in 1979 - and I've been toying with its peculiarities ever since.
Date and location of the next conference are not yet final - but we are negotiating for an August date on the East Coast (of the U.S.) Fred Sawyer ----- Original Message ----- From: "Edley McKnight" <[EMAIL PROTECTED]> To: <sundial@rrz.uni-koeln.de> Sent: Wednesday, November 26, 2003 3:30 AM Subject: Stab Dial > Dear Shadow Watchers, > > If anyone is interested in any "stab", "slit" or "groove" dials I'd enjoy > communicating with them. > > Here is a short introduction to a couple of them. > > Stab Dials - One > > If one were to find, or place a round circular > column so that it's length pointed toward the north or south > celestial pole, one could create a sundial as follows: > > 1. Place a non-elastic cord around the column, marking where the > ends crossed. > 2. Divide the cord into twenty-four equal parts between the > marks above. > 3. At some exact hour of sunlight align a blade (of 47 degrees > width and a half degree sharpness) for minimum shadow width with > the blade width parallel to the axis of the column, blade > centerline at right angles to the axis of the column, and sink it > into the surface sufficient to hold it in place. > 4. Place the cord around the column, aligning one mark with the > blade and mark the 24 spots. > 5. Re-sink the blade into the column at each mark corresponding > to the hours of sunlight, keeping the blade width aligned up and > down the column and the point directly toward the center of the > column. Marking them to show the correct hours. > > When the blade is inserted into any of these stab marks it would > indicate with a minimum shadow the correct hour of the day by > local solar time, thus being a "shadow plane" dial. > > If the blade is lost, or off doing something else somewhere, the > light reaching to the depth of the stab in the wood would > indicate the same time. > > This is one kind of stab dial. > > If one makes the same stabs into other surfaces, maintaining the > same alignment, it can be seen that they would work as well, even > if the stabs were scattered about rather than in order. > > Since it is difficult to look fully into the stab marks, some > people widen the marks into grooves roughly a quarter of an inch > wide or so and find they work well also when fully lit. These > seem to be commonly called "Groove dials" Others extend the > blade tip just through a thick shell, putting a colored filter > over the spot to indicate that certain time. > > I've come upon such insights from conversations and thought. If > there is a body of written material on these dials or related > ones, I would very much enjoy being informed of them! > > Edley McKnight > > 43.126N 123.358W > > > > > - > -
