Please don't do that. If someone has a response, they'll respond when
they're able. Keep in mind that this is a free resource, and that help
is on a voluntary basis. If this doesn't fit within the threshold you
have for a solution, then please consider other options. Spamming the
mailing list isn't the way.
Wade Blackwell wrote:
Anyone....Bueler....Bueler....?
-W
On Tue, 2008-04-29 at 06:41 -0700, Wade Blackwell wrote:
Good morning PFsense fans,
Greetings from the starting to get sunny Northwest. I am not sure if
what I am trying can be done or not. In concept I know it's possible but
I am not seeing the desired results where the rubber meets the road.
Basic setup is this;
Network A
1.1.1.1/24
|
|
|
I-net----PF---PPTP clients 3.3.3.3/28
|
|
|
IPsec tunnel to 2.2.2.0/24
Goal: To have PPTP clients connect in and connect to the PF and then
have access to 2.2.2.0/24 over the IPsec tunnel. The tricky part (I am
assuming) is that for the tunnel to come up the PPTP clients to bring
the IPsec tunnel up they need to be sourced from 1.1.1.0/24. What I did,
attempting to make this work, was to setup the advanced outbound NAT
allowing all PPTP clients destined for 2.2.2.0/24 to be natted with the
interface IP of network A. I am running 1.2-RC2 if that has any bearing.
If anyone has tried this or has some insight I would be stoked. Thanks
all.
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
