>yes, play with the Interfaces->Assign menus Paul, Thanks for the confirmation. In the VLAN Tab, I have:
Interface VLAN tag Description em2 50 NegriBossi In the Interface Assignment Tab, I have: Interface Network port LAN em0 WAN bge0 OPT1 em1 OPT2 VLAN 50 on em2 OPT3 em3 In the rules page on the OPT2 tab, I have: a * rule allowing all from all. The LAN tab has its * (from LAN net) rule. So when you say create rules for vlan50, the Rules interface still refers to the name of the Interface, not the vlan itself, correct? As a test to make sure there wasn't anything wrong in between switches etc, I untagged a non vlan aware wkst into vlan 50 on the switch pfsense is plugged into and it can see the remote machine fine. I then removed the vlan from pfsense and untagged OPT2 into vlan50 and had issues? I swapped ports and it sort of works, sporadic connectivity that sometimes works and sometimes does not. At this point, I think there is a cabling issue possibly or another problem outside the pfsense setup. I have to purchase some new cables and try this again. Thanks everyone, jlc --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
